
41
CD-G10000
CP-G10000S
References
Headphones
zBefore plugging in or unplugging the headphones, reduce the
volume.
zBe sure your headphones have a 1/8" (3.5 mm) diameter plug
and impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
zPlugging in the headphones disconnects the speakers automati-
cally. Adjust the volume using the VOL. control.
Troubleshooting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorized SHARP dealer or service center.
General
CD player
Symptom Possible cause
zThe clock is not set to the
correct time.
zDid a power failure occur? Reset
the clock. (Refer to page 19.)
zWhen a button is pressed,
the unit does not respond.
zSet the unit to the power stand-
by mode and then turn it back on.
zIf the unit still malfunctions, reset
it. (Refer to page 43.)
zNo sound is heard. zIs the volume level set to "0"?
zAre the headphones connected?
zAre the speaker wires discon-
nected?
Symptom Possible cause
zPlayback does not start. zIs the disc loaded upside down?
zPlayback stops in the mid-
dle or is not performed
properly.
zDoes the disc satisfy the stan-
dards?
zIs the disc distorted or
scratched?
zPlayback sounds are
skipped, or stopped in the
middle of a track.
zIs the unit located near excessive
vibrations?
zIs the disc very dirty?
zHas condensation formed inside
the unit?