37
CD-MPS66
CD-MPS600
References

!Headphones

"Before plugging in or unplugging the headphones, reduce the vol-
ume.
"Be sure your headphones have a 1/8" (3.5 mm) diameter plug
and are between 16 ohms and 50 ohms impedance. The recom-
mended impedance is 32 ohms.
"Plugging in the headphones disconnects the speakers automati-
cally. Adjust the volume using the VOLUME control.
Troubles ho oting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorized SHARP dealer or service center.
!General

!CD player

Symptom Possible cause
"The clock is not set to the
correct time.
"Did a power failure occur? Reset
the clock. (Refer to page 15.)
"When a button is pressed,
the unit does not respond.
"Set the unit to the power stand-
by mode and then turn it back on.
"If the unit still malfunctions, reset
it. (Refer to page 39.)
"No sound is heard. "Is the volume level set to "0"?
"Are the headphones connected?
"Are the speaker wires discon-
nected?
Symptom Possible cause
"Playback does not start. "Is the disc loaded upside down?
"Playback stops in the mid-
dle or is not performed
properly.
"Does the disc satisfy the stan-
dards?
"Is the disc distorted or
scratched?
"Playback sounds are
skipped, or stopped in the
middle of a track.
"Is the unit located near excessive
vibrations?
"Is the disc very dirty?
"Has condensation formed inside
the unit?