40
Viewing an Image from a PC
Use the PC-IN terminals to connect a PC.
A
• The PC input terminals are DDC1/2B-compatible.
• Refer to page 42 for a list of PC signals compatible with the System.
• Make sure to select the same signal values for the output signal of a PC and the input signal of the LCD-TV before connecting with the PC.
(See pages 41 and 42.)
• Depending on the PC being used, images may not be shown without converting the output signals into external output. Please refer to your
PC’s manuals regarding converting to external output.
To Audio output
terminal
To ANALOG
RGB terminal
To ANALOG RGB
output terminal
ø 3.5 mm stereo minijack cable
(commercially available)
RGB cable (supplied)
PC
To AUDIO
input terminal
Connecting a PC
Signal names for 15-pin mini D-sub connecter
15 14
13
12
9
11
10
87
6
54
3
21
Pin No. Signal name Pin No. Signal name Pin No. Signal name
1R6GND (Ground) qNot connected
2G7GND (Ground) wSDA
3B8GND (Ground) eHD
4Not connected 9+5V rVD
5CSYNC 0GND (Ground) tSCL
A
• Pin No. 5 on the LCD TV set is not used for inputting the signal.
• Pin No. 9 is not connected with the supplied RGB cable.
Displaying an Image from a PC
Connecting the thumbscrew cables
• Connect the thumbscrew cable
making sure that it fits correctly into
the terminal. Then, firmly secure
the connectors by tightening the
screws on both sides of the plug.
• Do not remove ferrite cores
attached to the RGB cable.
Ferrite core
To view an image from a PC, perform the following procedures.
1Select the PC mode using INPUT on the remote control or the LCD TV set. (See
page 17.)
2Select the PC input signal. (See page 41.)
3Select the PC sound input mode. (See page 26.)
4Adjust the “FINE SYNC.” items if the PC image does not come in clearly. (See page
41.)