Preparation

Using the remote control unit

Use the remote control unit by pointing it towards the remote control sensor on the TV. Objects between the remote control unit and the remote control sensor may prevent proper operation.

Cautions regarding the remote control unit

• Do not expose the remote control unit to shock. In addition, do not expose the remote control unit to liquids, and do not place in an area with high humidity.

• Do not install or place the remote control unit under direct sunlight. The heat may cause deformation of the remote control unit.

• The remote control unit may not work properly if the remote control sensor on the TV is under direct sunlight or strong lighting. In such cases, change the angle of the lighting or the TV, or operate the remote control unit closer to the remote control sensor.

Antennas

To enjoy a clearer picture, use an outdoor antenna. The following is a brief explanation of the types of connections that are used for a coaxial cable. If your outdoor antenna uses a 75-ohm coaxial cable with an F-type connector, plug it into the antenna terminal at the rear of the TV set.

1.A 75-ohm system is generally a round cable with F-type connector that can easily be attached to a terminal without tools (Commercially available).

F-type connector

75-ohm coaxial cable (round)

2.A 300-ohm system is a fl at “twin-lead” cable that can be attached to a 75-ohm terminal through a 300/75-ohm adapter (Commercially available).

NOTICE

F-type connector should be finger-

tightened only.

 

When connecting the RF cable to the TV set, do not tighten F-type connector with tools.

If tools are used, it may cause damage to your TV set. (The breaking of internal circuit, etc.)

F-type connector

300-ohm twin-lead cable (fl at)

75-ohm coaxial cable

Connecting Antenna Cable

1 Cable without a CATV

Cable TV lead-In

 

converter

 

2 VHF/UHF antenna

 

 

75-ohm coaxial cable (round)

 

3Combination VHF/ UHF antenna

or 75-ohm coaxial cable (round)

300-ohm twin-lead cable (flat)

Home Antenna terminal (75-ohm)

Coaxial cable (commercially available)

Home Antenna terminal (75-ohm)

Coaxial cable (commercially available)

Connect the antenna cable to the TV using one of the

methods in the illustration as shown (1, 2, 3 or 4).

VHF

UHF

 

300/75-ohm adapter

 

(commercially available)

ANTENNA ANTENNA

 

 

4 Separate VHF/UHF

300-ohm

Combiner

 

antenna

twin-lead cable

 

 

 

(commercially

 

300-ohm twin-lead cable

available)

 

 

 

 

 

 

IN

OUT

 

or

 

To TV antenna

 

75-ohm coaxial cable

 

 

 

 

terminal

12