_P. 28
6. Select the Input mode
Press INPUT P/R to display the INPUT list. Use INPUT P/R to select the Input mode, and use < / > to select the audio input terminal.
On the remote control
Shrinks
lower side.
Shrinks
upper side.
(When “Setup Guide” is set to “On”. See page 49.)
2 Follow the steps in the Setup Guide and adjust the focus, height (angle) and picture size.
3 After adjusting the focus, height (angle) and picture size, press ENTER to finish the
Setup Guide.
_P. 26
5. Correct trapezoidal distortion
Correcting trapezoidal distortion using Keystone Correction.
After the projector turns on, the Setup Guide appears.
1
4. Adjust the projected image with the Setup Guide
Start Easy
On the | On the remote | INPUT list |
| On the |
projector | control | INPUT | Audio | projector |
|
|
| ||
|
| 1 COMPUTER1 |
|
|
|
| 2 MONITOR OUT |
| On the remote |
|
| H HDMI |
| |
|
|
| control | |
|
|
|
|
_P. 29
7.Turn the computer on8.Turn the power offPress STANDBY/ON on the projector or STANDBY on the remote control, and then press the button again while the confirmation message is displayed to put the projector into Standby mode.
On the | |
On the remote | |
projector | control |
_P. 25
15