Sharp Warning, Projecting 3D images, Ending 3D projection, Using 3D Viewing Mode

Viewing Stereoscopic 3D Images (Continued)

		6	Press 3D MODE on the remote
Using 3D Viewing Mode			control to display the 3D MODE
			menu.
Use the following procedure to project			Info
3D images.			• If “An invalid button has been pressed.”
For operation of the 3D LCD shutter			is displayed, a 3D-compatible signal is
			not being input. Check the output signal
glasses and the 3D-video playback
			on the playback equipment.
equipment, see the corresponding
operation manual.		7	Press Q to set “DLP® Link™” to
	ENTER button
			“On”.
	O/Q buttons	8	Press ENTER to switch the mode
			and enable more natural 3D
			image viewing.
			Warning!
	3D MODE button		• If the projector, 3D-video playback
			equipment, and 3D LCD shutter
			glasses are not properly set, you may
Projecting 3D images			experience eye strain in addition to not
			being able to view the images in 3D.
1 Turn the projector on.		9	Press 3D MODE.
2			•  The 3D MODE menu will disappear.
	Turn the 3D-video playback
	equipment on.		Note
	•  Set the 3D-video playback equipment so
	that it outputs one of the signals listed in	• If the images are not displayed in 3D, repeat
	the Compatibility Chart in this operation
		steps 6 to 8.
	manual.
		• You can also use “DLP® Link™” and “DLP®
3 Switch the Input mode of the		Link™ Invert” on the menu screen to change
		the 3D setting.
	projector to enable input of 3D
	video signals.	Ending 3D projection
4	Operate the 3D-video playback	1	Press 3D MODE on the remote
	equipment and play back the 3D		control to display the 3D MODE
	content.		menu.
5	Turn the 3D LCD shutter glasses	2	“Off”.Press O to set “DLP	®	Link™” to
	on and place them over your eyes.
		3	Press 3D MODE.
			• The 3D MODE menu will disappear.

Useful Features

59