E-11
Setup & Connections

Connecting the Power Cord

Plug the supplied power cord into the AC socket on the back of the projector.

Connecting the Projector to a Computer

You can connect your projector to a computer for projection of full color computer images.
Power cord
QACCU5013CEZZ
Computer audio cable
QCNW-4870CEZZ
Computer cable
QCNW-5304CEZZ
Connecting the Projector

To a computer using the standard 15-pin (VGA) input

1Connect one end of the supplied computer cable to
the INPUT 1 port on the projector.
2Connect the other end to the Monitor output port on the
computer. Secure the connectors by tightening the
thumb screws.
3To use the built-in audio system, connect one end of
the supplied computer audio cable to the AUDIO INPUT
terminal on the projector.
4Connect the other end to the Audio output terminal on
the computer.
CAUTION
•Before connecting, be sure to turn both the projector and the
computer off. After making all connections, turn the projector
on first. The computer should always be turned on last.
•Please read the computer’s operation manual carefully.
•Refer to pages 55 and 56 “Input Signals (Recommended
Timing)” for a list of computer signals compatible with the
projector. Use with computer signals other than those listed may
cause some of the functions not to work.
When connecting this projector to a computer, select
“Computer/RGB” for “Signal Type” on the GUI menu. (See
page 40.)
•A Macintosh adaptor may be required for use with some
Macintosh computers. Contact your nearest Authorized Sharp
Industrial LCD Products Dealer or Service Center.