58
Troubleshooting Guide

If a fault occurs, run through the table below before taking your unit for repair.

If the fault persists, attempt to solve it by switching the unit off and on again. If this fails to resolve the situation, consult your

dealer. Under no circumstances should you repair the unit yourself as this will invalidate the guarantee!

PROBLEM POSSIBLE CAUSE REMEDY

No power
No playback
Malfunction
No picture
Noisy or distorted
picture
Abnormal picture or no
picture
Slight pause of picture
No sound
Noisy or distorted
sound
No playback of DVD
Video contents on a
DVD Audio.
No playback of the
desired area/layer on
a SACD.
Remote control unit
does not operate.
The AC input cord is disconnected.
Poor connection at AC wall outlet or the outlet is
inactive.
The disc is loaded upside down.
The disc is not playable.
The disc is dirty.
The rating level is not set correctly.
The symbol about invalid operation is displayed.
The disc is scratched, dirty badly or unplayable.
The video cords are disconnected.
The incorrect selection of input source on the TV.
The disc is not playable.
The PUREAUDIO indicator lights up on the front panel.
The unit is connected to a VCR directly and the
copyguard function is activated.
The disc is dirty.
It is in rapid advance or reverse playback, or in frame
advance playback.
The component video output signal is not selected
correctly.
The layer transition occurs during playback of DVD
Videos recoded in dual-layer format.
The audio cords are disconnected.
The speakers are disconnected to the amplifier.
The incorrect selection of input source on the amplifier.
Digital signals cannot be output from a SACD or a
DVD Audio.
The disc is dirty.
Poor connections.
DVD AUDIO AREA is set to DVD AUDIO.
The desired area/layer is not selected.
Batteries are not loaded or exhausted.
The remote sensor is obstructed.
Connect cord securely.
Check the outlet using a lamp or another appliance.
Reload the disc with the printed side up.
Use a playable disc.
Clean the disc.
Set the rating level setting correctly.
(Refer to When selecting the PARENTAL
CONTROL on page 48.)
Adjust the setting correctly.
(Refer to SYMBOL ABOUT INVALID OPERATION
on page 14.)
Press the POWER switch to switch the power off,
press the POWER switch again and then unload the
disc.
Connect the cords correctly.
Select the input source correctly.
Use a playable disc.
Turn off the pure audio function.
Connect the unit so that the picture signal is
transferred directly to the TV.
Clean the disc.
Sometimes a small amount of picture distortion may
appear. This is not malfunction.
Select the component video output signal correctly.
(Refer to When selecting the SCAN TYPE on page
34.)
Sometimes slight pause may occur.
This is not malfunction.
Connect the cords correctly.
Connect the speakers correctly.
Select the input source correctly.
Make analog audio connection.
Clean the disc.
Check the connections and connect all cords
securely.
Set the DVD AUDIO AREA to DVD VIDEO.(Refer to
When selecting the DVD AUDIO AREA on page 43.)
Select the desired.(Refer to To select a playback
area/layer on page 18.)
Replace the batteries.
Remove the obstacle.