Simplicity manual

Installation Instructions

Motion Control Retro Fit Kit

Part No. 5600266

For Ferris IS1500Z and Simplicity Citation Series Zero-Turn Riding MowersS/N: 2012636130 through 2013170251

Kit Contents

Part No.	Qty.	Description	Part No.	Qty.	Description
5404325A	1	Tab, Motion Control, Retro Fit - RH	5025011X8	2	Bolt, 5/16-18 X 1 GD5 YZ
5404369A	1	Tab, Motion Control, Retro Fit - LH	5025392	4	Nut, 5/16-18 Hex Nylock Flange

WARNING

A

Remove the ignition key prior to performing maintenance on the unit.

Before beginning any service work turn off the PTO, engage the parking brake, turn off the ignition, remove the ignition key, and disconnect the spark plug wire(s).

Installation			Reproduction			C
1.	Park the machine on a flat, level surface. Turn off the PTO,						B
	engage the parking brake, turn off the ignition, remove the			Figure 1. Existing Motion Control Setup
	ignition key, and disconnect the spark plug wire(s).
				A. 5/16-18 Hex Nylock Nuts
2.	Raise the seat plate to gain access to the motion control			B.	Dampener Controls
	arms and dampener controls.			C.	Motion Control Arms
3. Loosen and remove the 5/16-18 hex nylock nuts (A, Figure					E			D
	1) that secure the dampener controls (B) to the motion
		Not
	control arms (C). Discard the 5/16-18 hex nylock nuts.
4.	See Figure 2. Mount the left motion controlfortab (A, Figure			D
	2) onto the left side of the left motion control arm (B) so
	that the tab is pointing towards the rear of the machine and						F
	secure using a 5/16-18 X 1” bolt (C) and 5/16-18 nylock
	flange nut (D).
5.	See Figure 2. Mount the right motion control tab (E) onto				D			G
	the right side of the right motion control arm (F) so that the
					A
	tab is pointing towards the rear of the machine and secure
	using a 5/16-18 X 1” bolt and 5/16-18 nylock flange nut.
6. Install the dampener controls (G) to the motion control tabs				C
	and secure using 5/16-18 nylock flange nuts as shown in
						B
	figure 2.
				Figure 2. New Dampener Tabs Installed
				A. Left Motion Control Tab
				B. Left Motion Control Arm
				C.	5/16-18 X 1” Bolt
				D.	5/16-18 Nylock Flange Nut
				E.	Right Motion Control Tab
				F.	Right Motion Control Arm
				G.	Dampener Control

Copyright © 2009 Briggs & Stratton Power Products Group LLC Milwaukee, WI, USA. All rights reserved.

	Form No.: 5404370
	Revision: A
	Rev. Date: 03/2009
1	TP 200-7411-A-SK-F