3

unit assembly

Note: Please refer to Parts List for correct part identification and placement.
FRONT WHEEL ASSEMBLY
Place Mounting Bracket against lower right
corner of Blower Housing, aligning holes in
bracket with threaded studs in housing. Secure
with three 3/8-16 hex nuts, split lock washers
and flat washers. Tighten securely.
Install Front Wheel between forks in bracket
and secure with 5/8-11 x 5” hex bolt and lock
nut. Tighten snugly while allowing for free
rotation of wheel.
HANDLE ASSEMBLY
The upper handles are shipped in the folded
storage position. To unfold, loosen two handle
knobs and rotate up to the operating position.
The upper handles are secured with four knobs.
Insert two 5/16-18 x 2 curved head bolts
through the handles directly below the two
shipping knobs. Place one internal tooth lock
washer on each of the bolts. Thread knobs onto
curved head bolts. Tighten all four knobs
securely.

Assembly complete. Your unit is now ready to be started and checked for proper operation.

Some minor final adjustments may be required; see the Maintenance portion of this manual.
1