Sonic Impact Technologies USB Mat

Attaching the SONIC GUARD USB Mat

If your system meets these requirements, then attaching the USB Mat in your workspace is the

next step. Connect the USB cable to an open USB port on your computer. Windows will load the

appropriate USB keyboard drivers once the USB Mat is attached. If the USB Keyboard drivers are

not currently resident on your system, you will be asked to place your Windows Operating System

disk into your CD drive. Follow the directions provided by Windows during this install.

Note:

There are no USB drivers provided on the SONIC GUARD Configuration Disk. All USB drivers will

be provided by the Windows 98SE, Windows 2000 or Windows XP operating systems.

Configuration

The USB Mat has several configurable settings that are controlled via the SONIC GUARD Configuration

program. Place the supplied SONIC GUARD Configuration CD into your CD drive and run the supplied

program (SonicGuard.exe). Click on the “Sonar” tab and you will see the screen below.

Figure 2: SONIC GUARD Sonar Configuration Screen