Sony 4-180-179-16(1) 1, 2, 3, 1, 2

5GB

Setting Up

Refer to the supplied Table-Top Stand leaflet

for proper attachment for some TV models.

•For best picture quality, do not expose the screen

to direct illumination or sunlight.

•If the TV is brought directly from a cold to a warm

location, or is placed in a very damp room, or is

placed in a room in which heating has just been

turned on, moisture may condense on the surface

or inside the TV. Should this occur, turn off the

TV and leave the TV off until the moisture

evaporates, and then the TV can be used. If you

notice moisture condensation between the glass

panel and the LCD, turn on the TV and the

condensation will evaporate after the TV has

warmed up.

For KDL-52/40NX803, KDL-46/

40NX703

1Place the TV set on the Table-Top

Stand.

2Fix the TV to the Table-Top Stand

according to the arrow marks that

guide the screw holes using the

supplied screws.

•If using an electric screwdriver, set the tightening

torque at approximately 1.5 N·m {15 kgf·cm}.

3After all the screws are tightened,

attach the supplied stand rear cover to

the Table-Top Stand.

For KDL-55NX813, KDL-46/40NX713

1Align with the two dowels of the Table-

Top Stand, and gently place the TV,

checking the f mark is facing the front.

2Attach the TV and Table-Top Stand

with the supplied screw and hexagon

wrench.

•Set the torque setting to approximately 3 N·m {30

kgf·cm}.

Reattaching the Table-Top Stand to the

Attach to the original position using the

removed screws. See “Detaching the Table-

Top Stand form the TV” (page9).

(Continued)