Specifications
HARD DISK RECORDERS / FLEXICART
46
DSR-DR1000PHard Disk Recorder
General
Power requirements AC 100 V to 240 V, 50/60 Hz
Power consumption 60 W
Operating temperature 5 °C to 40 °C (41 °F to 104 °F)
Storage temperature -20 °C to 60 °C (-4 °F to 140 °F)
Operating humidity Less than 80%
Storage humidity Less than 90%
Mass 7.5 kg (16 lb 10 oz)
Dimensions (W x H x D) 210 x 130 x 422 mm (8 3/8 x 5 1/8 x 16 5/8 inches, without projection)
Video Performance
Bandwidth Luminance: 25 Hz to 5.0 MHz +1.0
(via analogue component I/O) Chrominance: 25 Hz to 2.0 MHz +1.0/-2.0 dB
S/N ratio More than 54 dB
(via analogue component I/O)
K-factor (K2T, KPB) Less than 2%
Y/C delay Less than 30 ns
Audio Performance
Frequency response 2CH mode (48 kHz/16-bit): 20 Hz to 20 kHz ±1.0 dB
4CH mode (32 kHz/12-bit): 20 Hz to 14.5 kHz ±1.0 dB
Dynamic range More than 87 dB
Distortion (THD + N) Less than 0.07% (48 kHz)
Input Signals
VIDEO (ANALOGUE) REF. Video: BNC (2)
0.3 Vp-p, 75 Ωsync negative
Composite Video: BNC (2), loop-through connection (*1)
1.0 Vp-p, 75 Ω, sync negative
Component: BNC (3) (*1)
Y: 1.0 Vp-p, 75 Ω, sync negative
R-Y, B-Y: 0.7 Vp-p, 75 Ω(100% colour bar)
S-Video: BNC (2) (*1)
Y: 1.0 Vp-p, 75 Ω, sync negative
C: 0.3 Vp-p, 75 Ω(at burst level)
VIDEO (DIGITAL) SDI: BNC (1)
Conforms to Serial Digital Interface (270 Mb/s), ITU-R BT.656
i.LINK (DV): 6-pin (1)
IEEE 1394-based
AUDIO (ANALOGUE) Audio: XLR 3-pin female (2)
-6/-3/0/+4 dBu (selectable by menu), high impedance
AUDIO (DIGITAL) AES/EBU: BNC (2)
75 Ω, unbalanced
Time Code BNC (1), 0.5 Vp-p to 18.0 Vp-p, 3 kΩunbalanced
Output Signals
VIDEO (ANALOGUE) Video 1/2 (SUPER): BNC (2) (*2)
Composite, 1.0 Vp-p, 75 Ω, sync negative
Component: BNC (3) (*2)
Y: 1.0 Vp-p, 75 Ω, sync negative
R-Y, B-Y: 0.7 Vp-p, 75 Ω(100% colour bar)
S-Video: BNC (2) (*2)
Y: 1.0 Vp-p, 75 Ω, sync negative
C: 0.3 Vp-p, 75 Ω(at burst level)
VIDEO (DIGITAL) SDI: BNC (2)
Conforms to Serial Digital Interface (270 Mb/s), ITU-R BT.656
i.LINK (DV): 6-pin (1)
IEEE 1394-based
AUDIO (ANALOGUE) Audio: XLR 3-pin male (2)
-6/-3//0/+4 dBu (selectable by menu)
Monitor: RCA (1)
-9 dBu, 47 kΩ, unbalanced (-18 dBFS), volume center
Headphone: JM-60 headphone jack (1)
- ∞to -11 dBu, 8 Ω, unbalanced (-18 dBFS)
AUDIO (DIGITAL) AES/EBU: BNC (2), 75 Ω, unbalanced
TIME CODE BNC (1), 2.2 Vp-p, 600 Ω, unbalanced
REMOTE RS-422A: D-sub 9-pin, female (2)
Control: Mini jack (1)
Network Ethernet (1): 10Base-T/100Base-TX Ethernet, RJ-45 modular jack
DSR-DU1 Hard Disk Recorder
General
Power requirements DC 7.2 V (battery), DC 8.4 V (AC adaptor)
Power consumption 5.6 W
Mass 500 g (1 lb 1 oz)
Dimensions (W x H x D) 44 x 101 x 142 mm
Operating temperature 0 °C to 40 °C
Storage temperature -20 °C to 60 °C
Operating Humidity Less than 85 % (without dew condensation)
Input/Output Terminals
DV IN/OUT i.LINK x1 (IEEE1394 4-pin)
Remote 4-pin Stereo mini Jack x1
DC IN x1
Supplied Accessories
Warranty card
Operation manual
i.LINK cable (4-pin to 4-pin)
Remote controller (RM-LG2)
Battery (CR2032)
Case