Adjusting the sound characteristics

You can adjust the balance, fader, low pass filter and subwoofer volume.

1 Press (SEL) repeatedly until “BAL,” “FAD,” “LPF” or “SUB” appears.

Each time you press (SEL), the item changes as follows:

LOW*1 t MID*1 t HI*1 t

BAL (left-right) t FAD (front-rear) t LPF (low pass filter)*2*3 t

SUB (subwoofer volume)*2*4

*1 When EQ3 is activated (page 21).

*2 When “SUB” is selected (page 20).

*3 The cut off frequency is adjustable to 78 Hz, 125 Hz, or OFF.

*4 The volume level is adjustable between –10 and +10 steps. (Below –10, “ATT” is displayed.)

2 Press the volume +/– button to adjust the selected item.

Note

Adjust within 3 seconds after selecting the item.

Quickly attenuating the sound

Press (ATT).

After “ATT-ON” momentarily appears, “ATT” appears in the display.

To restore the previous volume level, press (ATT) again.

Tip

When the interface cable of a car telephone is connected to the ATT lead, the unit decreases the volume automatically when a telephone call comes in (Telephone ATT function).

Changing the sound and display settings

The following items can be set:

REAR/SUB*1 — to switch the audio output REAR or SUB.

Select “REAR” to output to a power amplifier.

Select “SUB” to output to a subwoofer.

A.SCRL (Auto Scroll)*2 (page 12).

M.DSPL (Motion Display) — to turn the motion display on or off.

Select “ON” to activate the motion display (the moving pattern appears in the display).

Select “OFF” to deactivate the motion display.

DEMO*1 — to turn the demonstration display on or off.

Select “ON” to activate the demonstration display (the demonstration starts about 10 seconds after the unit is turned off).

Select “OFF” to deactivate the demonstration display.

BEEP*3 — to turn the beeps on or off.

DIM — to change the brightness of the display.

Select “ON” to dim the display.

Select “OFF” to deactivate the Dimmer.

20