Press (MENU).

Adjusting the equalizer curve

1

2 Press either side of (PRESET) repeatedly

until “EQ7 TUNE” appears, then press (ENTER).

3 Press either side of (SEEK) to select the desired equalizer curve, then press (ENTER).

Each time you press (SEEK), the item changes.

4 Select the desired frequency and level.

1Press either side of (SEEK) to select the desired frequency.

Each time you press (SEEK), the frequency changes.

62 Hz y 157 Hz y 396 Hz

y 1.0 kHz y 2.5 kHz y 6.3 kHz y 16.0 kHz

2Press either side of (PRESET) to adjust the desired volume level.

The volume level is adjustable by 1 dB steps from –10 dB to +10 dB.

To restore the factory-set equalizer curve, press (ENTER) for two seconds.

5 Press (MENU) twice.

When the effect setting is complete, the normal playback mode appears.

Additional

Information

Maintenance

Fuse replacement

When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In such a case, consult your nearest Sony dealer.

Fuse (10 A)

Warning

Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit.

Cleaning the connectors

The unit may not function properly if the connectors between the unit and the front panel are not clean. In order to prevent this, detach the front panel (page 8) and clean the connectors with a cotton swab dipped in alcohol. Do not apply too much force. Otherwise, the connectors may be damaged.

Main unit

Back of the front panel

18