Polarity of the plug

Troubleshooting

Precautions

WARNING
CAUTION
The use of optical instruments with this product will increase eye

equipment off and on, the user is encouraged to try to correct the interference by one or more of the

GeneralThe power does not come on.

•Connect the AC power adaptor securely.

•Make sure the batteries are inserted correctly.

•Replace all the batteries with new ones if they are weak.

There is no audio.

•Unplug the headphones when listening through speakers.

Noise is heard.

•Someone is using a portable telephone or other equipment that emits radio waves near the player. tMove the portable telephone, etc., away from the player.

CD PlayerThe CD does not play or “– –” lights in the display even when a CD is in place.

•Place the CD with the label surface facing you.

•Clean the CD.

•Take out the CD and leave the CD compartment open for about an hour to dry moisture condensation.

•The CD-R/CD-RW was not finalized. Finalize the CD-R/CD- RW with the recording device.

•There is a problem with the quality of the CD-R/CD-RW, recording device or application software.

RadioThe audio is weak or has poor quality.

•Replace all the batteries with new ones if they are weak.

•Move the player away from the TV.

The picture of your TV becomes unstable.

•If you are listening to an FM program near the TV with an indoor antenna, move the player away from the TV.

After trying the above remedies, if you still have problems, unplug the AC power adaptor and remove all the batteries. After all the indications in the display disappear, plug the AC power adaptor and insert the batteries again. If the problem persists, please consult your nearest Sony dealer.

On safety

•As the laser beam used in the CD player section is harmful to the eyes, do not attempt to disassemble the casing. Refer servicing to qualified personnel only.

•Should any solid object or liquid fall into the player, unplug the player, and have it checked by qualified personnel before operating it any further.

•Discs with non-standard shapes (e.g., heart, square, star) cannot be played on this player. Attempting to do so may damage the player. Do not use such discs.

Cleaning the cabinet

•Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as alcohol or benzine.

On power sources

• For AC operation, use

the supplied AC power

adaptor; do not use any other type.

• The player is not disconnected

from the AC power source (mains)

as long as it is connected to the

wall outlet, even if the player itself

has been turned off.

• Unplug the player from the wall

outlet when it is not to be used for

an extended period of time.

• For battery operation, use four size

AA (R6) batteries.

• When the batteries are not to be

On operation

•If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lenses inside the CD player section. Should this occur, the player will not operate properly. In this case, remove the CD and wait about an hour for the moisture to evaporate.

If you have any questions or problems concerning your player, please consult your nearest Sony dealer.

Notes on CDs

• Before playing, clean the CD with a cleaning cloth. Wipe the CD from the center out.

•Do not use solvents such as benzine, thinner, commercially available cleaners or anti-static spray intended for vinyl LPs.

•Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be a considerable rise in temperature inside the car.

•Do not stick paper or sticker on the CD, nor scratch the surface of the CD.

•After playing, store the CD in its

case.

If there is a scratch, dirt or fingerprints on the CD, it may cause tracking error.

Personal

Audio

System

Operating Instructions
CFD-E10

Sony Corporation ©2002

Printed in China

3-234-994-11(1)

To prevent fire or shock hazard, do not expose the player to rain or moisture.

This symbol is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

hazard.
WARNING

Do not install the appliance in a confined space, such as a bookcase or built-in cabinet. To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the appliance.

InformationFor customers in the USA

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the

following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.

Owner's Record

The model number is located at the bottom and the serial number is located in the battery compartment.

Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product.

Model No. CFD-E10
Serial No. __________________
The sound drops out.

•

Reduce the volume.

•

Clean the CD, or replace it if the

used, remove them to avoid

damage that can be caused by

battery leakage or corrosion.

Specifications

For customers in the USA

Please register this product on line at http://www.sony.com/ productregistration.

CD is badly damaged.

• Place the player in a location free

from vibration.

• Clean the lens with a commercially

available blower.

• The sound may drop out or noise

may be heard when using poor

quality CD-Rs/CD-RWs or if there

is a problem with the recording

device or application software.

• The nameplate indicating operating

voltage, power consumption, etc. is

located at the bottom.

On placement

• Do not leave the player in a

location near heat sources, or in a

place subject to direct sunlight,

excessive dust or mechanical

shock.

• Do not place the player on an

inclined or unstable place.

• Do not place anything within 10

CD player section

System

Compact disc digital audio system Laser diode properties

Material: GaAlAs

Wave length: 780 nm

Emission duration: Continuous

Laser output: Less than 44.6 µW (This output is the value measured at a distance of about 200 mm from the objective lens surface on the optical pick-up block with 7 mm aperture.)

Spindle speed

General

Speaker

Full range: 5.7 cm dia., 2.7 Ω , cone type (2)

Outputs

Headphones jack (stereo minijack) For 8 - 32 ohms impedance headphones

Power output

1 W + 1 W (at 2.7 Ω , 10 % harmonic distortion in AC operation)

Power requirements DC IN 6 V accepts:

Proper registration will enable us to send you periodic mailings about new products, services and other important announcements. Registering your product will also allow us to contact you in the unlikely event that the product needs adjustment or modification. Thank you.

Lens

mm of the side of the cabinet. The

ventilation holes must be

unobstructed for the player to

operate properly and prolong the

life of its components.

• If the player is left in a car parked

in the sun, be sure to choose a

location in the car where the player

will not be subjected to the direct

rays of the sun.

• Since a strong magnet is used for

the speakers, keep personal credit

cards using magnetic coding or

spring-wound watches away from

the player to prevent possible

damage from the magnet.

200 r/min (rpm) to 500 r/min (rpm) (CLV)

Number of channels 2

Frequency response

20 - 20,000 Hz +1/–2 dB Wow and flutter

Below measurable limit

Radio section

Frequency range FM: 87.5 - 108 MHz AM:530 - 1,710 kHz

Antennas

FM: Telescopic antenna

AM: Built-in ferrite bar antenna

Supplied AC power adaptor for use with 120 V AC, 60 Hz

6 V DC, 4 size AA (R6) batteries Power consumption

DC 11.5 W Battery life

When playing a CD:

Sony R6P: approx. 2 hours

Sony alkaline LR6: approx 4 hours Dimensions

Approx. 315 ⋅ 131 ⋅ 70 mm (w/h/d) (12 5⁄8 ⋅ 5 1⁄4 ⋅ 2 7⁄8 inches) (incl. projecting parts)

Mass

Approx. 920 g (2 lb.) (incl. batteries) Supplied accessory

AC power adaptor (1)

Design and specifications are subject to change without notice.

Optional accessories

Sony MDR headphone series