Connecting your camcorder to your computer – Introduction

3 Follow the instructions given in the on- screen messages. When the “Setup Type” screen appears, make sure that [NTSC] is selected and continue the procedure. The “InstallShield Wizard Complete” screen appears.

4 Click [Finish].

The installation of ImageMixer is completed. The installation screen of WIN ASPI appears (Windows 2000 Professional and Windows XP users only).

Connecting your camcorder to

the computer

You can connect only one camcorder to every single computer. Operations are not guaranteed if you connect your camcorder via a USB hub or to the USB port not equipped with your computer at default.

For Microsoft Windows XP users

1

Connect the AC adaptor to your

2

camcorder.

 

Set the mode dial to

(Play/Edit).

3

Turn the power on your camcorder by

 

sliding the POWER switch upward

 

while pressing the green button.

4

Connect the (USB) jacks of the

 

camcorder and the

(USB) port of the

computer using the USB cable supplied with your camcorder.

USB port

5 Follow the instructions given in the on- screen messages.

6 When The “InstallShield Wizard Complete” screen appears, click [Finish].

7 Take out the CD-ROM from the CD- ROM drive after the computer restarts.

Note

On a computer without DirectX 8.0a or later, DirectX installation starts. Follow the instructions given in the on-screen messages and restart the computer after the installation is complete.

USB cable

USB jack

Your computer recognizes the camcorder, and the “Found New Hardware Wizard” starts.

To replace WIN ASPI

 

To be able to use the ImageMixer CD writing

 

function, you need to install WIN ASPI. If a

 

different writing application was previously

 

installed, its writing function may not work

 

correctly. If that happens, reinstall the original

 

application and replace WIN ASPI. Note that

 

the ImageMixer CD writing function may not

92

work properly.