FM/AM CD Clock Radio
Operating Instructions
Owner’s Record
The model number and the serial number are located on the bottom.Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product.
Model No.ICF-CD7000
| © 2007 Sony Corporation | Printed in China |
Please register this product on line at http:/www.sony.com/productregistration. Proper registration will enable us to send you periodic mailings about new products, services, and other important announcements. Registering your product will also allow us to contact you in the unlikely event that the product needs adjustment or modification. Thank you.
WARNING
To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture.
To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only.
Do not install the appliance in a confined space, such as a bookcase or
To reduce the risk of fire or electric shock, do not place objects filled with liquids, such as vases, on the apparatus.
Connect the apparatus to an easily accessible AC outlet. Should you notice an abnormality in the apparatus, disconnect the main plug from the AC outlet immediately.
This symbol is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
The graphical symbols are at the bottom of the unit.INFORMATIONThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.—Increase the separation between the equipment and receiver.—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/ TV technician for help.You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.
CAUTIONThe use of optical instruments with this product will increase eye hazard.WARNINGBattery may explode if mistreated.Do not recharge, disassemble or dispose of in fire.For the state of California, USA onlyPerchlorate Material – special handling may apply, See www.dtsc.ca.gov/hazardouswaste/perchlorate Perchlorate Material: Lithium battery contains perchlorate
Features
Illumination (High/Low/Off)Triple time display: A main display for the clock and two
Precautions
Use the power source specified in “Specifications” to operate the unit.The name plate indicating operating voltage, etc. is located on the bottom of the unit.
To disconnect the power cord (mains lead), pull it out by the plug, not the cord.
Do�� not��� �����carry the��� unit���� by�� the��� FM�� wire���� antenna������� and���
the AC power cord.Do not leave the unit in a location near a heat source such as a radiator or air duct, or in a place subject to direct sunlight, excessive dust, mechanical vibration, or shock.
Allow adequate air circulation to prevent internal heat
Should any solid object or liquid fall into the unit, unplug the unit and have it checked by a qualified personnel before operating it any further.
When the casing becomes soiled, clean it with a soft cloth dampened with mild detergent solution. Never use abrasive cleansers or chemical solvents, as they may mar the casing.
If you have any questions or problems concerning your unit, please consult your nearest Sony dealer.
Troubleshooting
Should the problem persists after you have made the following checks, consult your nearest Sony dealer.
The clock flashes “AM 12:00” due to a power interruption.The battery is low. Replace the battery. Remove the old battery and install a new one.
The CD, radio or buzzer alarm does not sound at the preset alarm time.Hasn’t “ALARM A” or “ALARM B” in the display gone out?The CD or radio alarm is activated but no sound comes on at the preset alarm time.
Has VOLUME been adjusted ?The CD player does not operate.Did you close the CD compartment lid?Did you insert the disc correctly?The disc should be inserted with the label side up.Dusty or defective disc — Clean the disc with an optional cleaning cloth. Wipe the disc from the center out.
Take out the CD and leave the CD compartment open for about an hour to allow condensation to evaporate.
Sporadic loss of sound during CD operation.Dusty or defective disc — Clean or replace the disc.Excessively high volume — Reduce the volume.Strong vibration.No sound comes from the speakers.Has VOLUME been adjusted ?
Specifications
AUDIO POWER SPECIFICATIONSPOWER OUTPUT AND TOTAL HARMONIC DISTORTIONWith150 – 10 000 Hz; rated 0.8 W per
Laser diode properties: Material: GaAlAs Wavelength: 785 – 800 nm Emission duration: Continuous Laser output: Less than 44.6 µW
(This output is the value measured at a distance of about 200 mm from the objective lens surface on an optical
Input:
Approx. 170 136 204 mm (w/h/d) (Approx. 6 3/4 5 3/8 8 1/8 inches) incl. projecting parts and controls
Mass:Approx. 1 700 g (3 lb 12 oz) incl. CR2032 batteryDesign and specifications are subject to change without notice.This unit includes a preinstalled Sony Lithium battery (CR2032) as