D:\SONY TV\SY130273_Clover 6\4489955111_US\US03STU.fm
KDL-48W600B/48W590B/48W580B/40W600B/40W590B/40W580B
4-489-955-11(1)
11US
US
~
•If using an electric screwdriver, set the
torque at approximately 1.5 N·m
{15 kgf·cm}.
To detach the Table-Top Stand from the TV,
remove the screws fixed in step 2.
~
•Do not remove the Table-Top Stand for any
reason other than to install corresponding
accessories on the TV.
•When removing the Table-Top Stand from
the TV, lay the display face down on a stable
work surface that is larger than the TV.
•To prevent damaging the surface of the LCD
display, make sure to place a soft cloth on
the work surface.
•Be sure the TV is vertical before turning on.
To avoid uneven picture uniformity do not
power on the TV with the LCD panel facing
down.
•When attaching the Table-Top Stand again,
be sure to fasten the screws (previously
removed) to the original holes on the rear of
the TV.
~
•You can bundle the AC adapter as an
optional step. Do not bundle it for any reason
other than to wall-mount the TV.
•Make sure that the label is facing outwards
when bundling AC adapter.
2: Connecting the TV~
•Use an antenna cable connector no greater
than 14 mm thick.
•When connecting the cable to the Cable/
Antenna, input finger tighten only, over
tightening the connection can damage the
TV.
•Before moving the TV, disconnect all of the
cables connected to the TV to prevent
damaging the TV when it is moved.
•Use an HDMI cable connector within 12 mm
(thickness) × 21 mm (width).
•For more information on connections, refer to
the i-Manual.
xShown with a Set Top Box with
HDMI connection
Detaching the Table-Top
Stand from the TV
Bundling the AC adapter
22
1133
Set Top Box
(Continued)