KDL32XBR950 | Checking the Supplied | 1 | Connecting the | 3 | Connecting a Cable or | 4 |
KDL42XBR950 | Accessories | Display Unit to the | Antenna | |||
|
| Media Receiver Unit |
|
Quick Start Guide
Thank you for purchasing this Sony product.
After following this step by step guide you will be able to:
–Insert batteries into the remote control.
–Connect the display unit to the media receiver unit.
–Connect a cable or antenna to your TV.
–Tune your TV .
–Program your remote control
Now you are ready for viewing TV programs.
US
© 2003 Sony Corporation
Printed in Japan | |
|
Remote Control | Two size AA | Display Interface |
batteries (R06 Type): | Cable: |
Antenna Cable: | Two AC power |
| cords: |
• | Speaker jack covers | • | Quick Start Guide |
| (KDL42XBR950 only) | • | Warranty Card |
• | Operating Instructions |
|
|
Inserting Batteries into 2 the Remote Control
1Open the battery compartment as illustrated below.
2Insert two size AA batteries (supplied) by matching the e and E terminals on the batteries to the diagram inside the battery compartment.
3Close the battery compartment.
Remove the batteries to avoid damage from possible battery leakage whenever you anticipate that the remote control will not be used for an extended period.
Handle the remote control with care.
Avoid dropping it, getting it wet, placing it in direct sunlight, near a heater, or where the humidity is high.
1Connect the display interface cable (supplied) to the DISPLAY SIGNAL IN jacks, and the AC power cord (supplied) to the AC IN jack of the unit.
KDL32XBR950KDL42XBR950
| SONY EXCLUSIVE CABLE ONLY |
| |
| WHITE | BLACK |
|
| DISPLAY SIGNAL IN |
| |
Tighten the screw | Display Interface | AC power cord | |
slowly until the | cable (supplied) | (supplied) | |
screw is stabilized.
When you install KDL42XBR950, use the optional accessories as follows:
•SONY TABLE TOP STAND:
•SONY
•SONY FLOATING STAND:
2Connect the other end of display interface cable to the media receiver unit’s DISPLAY SIGNAL OUT jacks, and connect the media receiver unit’s AC power cord (supplied) to the AC IN jack .
| CABLE |
S400 | VHF/UHF |
(TS/DV/MICROMV) |
|
i.LINK |
|
WHITE | BLACK ~ AC IN |
DISPLAY SIGNAL OUT | |
Display Interface cable | AC power cord |
(supplied) | (supplied) |
Tighten the screw slowly |
|
until the screw is stabilized. |
|
Be sure to use the supplied AC power cords.
When connecting optional components, do not connect the AC power cords to wall outlets until you have completed making all connections.
Do not tighten the screws too much. It may damage the screws. Do not use damaged cables, such as cables whose connectors are deformed.
Handle the display interface cable with care. This unit may fall and cause injury if accidently knocked or pulled by the connected cable. To store the AC power cord and the display interface cable in the stand;
(KDL32XBR950)
See “Storing the AC power cord and the display interface cable into the stand (KDL32XBR950 only)” on page 28 of the operating instructions.
(KDL42XBR950)
See the operating instructions for the optional tabletop stand.
The way in which you will connect your TV varies, depending on how your home receives a signal (cable, cable box, antenna) and whether or not you plan to connect a VCR or other optional AV equipment.
See examples A, Bor Cto connect your TV. For details on other connection examples, see pages 31 to 54 of the operating instructions.
ACable or Antenna
For best results, use this connection if you are connecting a cable or an antenna and you;
•Do not need a cable box to unscramble channels.
•Do not intend to connect a VCR.
For antenna connection, use the supplied antenna cable.
Rear of Media Receiver Unit
| CABLE |
S400 |
|
(TS/DV/MICROMV) |
|
i.LINK |
|
WHITE | BLACK ~ AC |
DISPLAY | OUT |
Antenna cable | or | |
(supplied) |
| (not supplied) |
When using an indoor antenna, such as
BCable Box and Cable
For best results, use this connection if;
•Your cable company scrambles some channels, such as premium channels (which requires you to use a cable box), but does not scramble all channels.
•You do not have a VCR.
CATV |
|
| IN OUT | |
| Cable Box | coaxial cable | ||
cable | Splitter | (not supplied) | ||
| coaxial cable |
|
| |
|
| (not supplied) | Antenna cable | |
|
|
| (supplied) |
|
| Rear of Media Receiver Unit |
| ||
|
|
|
| CABLE |
|
|
| S400 | VHF/UHF |
|
|
|
| |
|
| (TS/DV/MICROMV) |
| |
|
|
| i.LINK |
|
|
|
| WHITE | BLACK ~ AC IN |
|
|
| DISPLAY SIGNAL OUT | |