Basic Set Up
Using the Remote Control
Inserting the batteries
Insert two size AA (R6) batteries (supplied) by matching the + and – on the batteries to the diagram inside the remote control’s battery compartment.
Notes:
•Remove the batteries to avoid damage from possible battery leakage whenever you anticipate that the remote control will not be used for an extended period.
•Handle the remote control with care. Avoid dropping it, getting it wet, or placing it in direct sunlight, near a heater or where the humidity is high.
•Your remote control can be programmed to operate most video equipment.
(see “Operating Video Equipment” on page 43)
14
Setting Up the Projection TV Automatically
The AUTO SET UP feature will allow you to set the
The AUTO SET UP feature does not apply for installations that use a cable box for all channel selection.
You can also set up the projection TV manually. (see “Using the Channel Set Up menu” on pages 26 and 27)
Notes:
•Before you perform AUTO SET UP again, make sure that the input from ANT (not AUX) is selected by pressing ANT until “AUX” does not appear next to the channel number.
•Perform this function during the day, with the antenna and/or cable properly connected, to ensure that all available channels will be broadcasting and receivable.
•When you perform AUTO SET UP, all the settings in the Video, and Audio menus are reset to the factory settings.
Using the buttons on the front panel and inside the
Front panel:
FLASH FOCUS TV/VIDEO – VOLUME + | – CHANNEL + POWER TIMER/STAND BY |
Inside the
FLASH FOCUS TV/VIDEO
SET UP MENU
1Press POWER to turn on the projection
TV.
POWER
2Press SET UP inside the
| E n g l i s h : | [ C H + ] |
| E s p a ñ o l : | [ C H – ] |
| F r a n ç a i s : | [ V O L + ] |
SET UP | A u t o S e t U p : | [ V O L – ] |
|
| |
| First please connect |
|
| the antenna. |
|
| Press [ SET UP ] | to exit. |