Operating a Cable Box or Satellite Receiver (SAT)

Setting the Manufacturer's Code

You can program the supplied remote control to operate a cable box or satellite receiver.

Press CODE SET, SAT/CABLE (FUNCTION), and the 0-9 buttons to enter the manufacturer’s code number (see the following chart), then press ENTER.

For example, to operate a Sony satellite receiver:

CODE SET

FUNCTION

 

ENTER

SAT/CABLE

0

 

8

1

Manufacturer code numbers (cable box)

Manufacturer

Code

Hamlin/Regal

222, 223, 224, 225, 226

Jerrold/G. I.

201, 202, 203, 204, 205,

 

222, 206, 207, 208, 218

Oak

227, 228, 229

Panasonic

219, 220, 221

Pioneer

214, 215

Scientific Atlanta

209, 210, 211

Tocom

216, 217

Zenith

212, 213

Manufacturer code numbers (satellite receiver)

Manufacturer

Code number

Sony

801 (preset code for

 

remote control)

Geneal Electric

802, 808

Hitachi

805

Hughes

804

Panasonic

803

RCA/PROSCAN

802

Toshiba

806, 807

To operate the cable box or satellite receiver (SAT)

1Press SAT/CABLE (POWER) [Green Button] to turn on/off the cable box or satellite receiver.

2Press SAT/CABLE (FUNCTION).

3For other operations, refer to the operating instructions that come with the equipment.

The GUIDE and INDEX (blue-labeled) buttons can be used only with a satellite receiver.

If the remote control doesn’t work

•Try repeating the set up procedures using the other codes listed for your equipment.

To operate the projection TV

Press TV (FUNCTION). Then use the projection TV control buttons to control the projection TV.

Tips z

•If more than one code number is listed, try entering them one by one until you come to the correct code for your equipment.

•If you enter a new code number, the code number you previously entered at that setting is erased.

•In some rare cases, you may not be able to operate your equipment with the supplied remote control. In this case, use the equipment’s own remote control unit.

•Whenever you remove the batteries — to replace them, for example — if too much time is taken, the code numbers may revert to the factory setting and must be reset.

53