– 38 –
KV-ES29M90
RM-916
•REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short circuit the anode of the picture tube and
the anode cap to the metal chassis, CRT shield or carbon paint on the
CRT.
•REMOVING PROCEDURES
1Do not damage the surface of anode-caps with sharp shaped objects.
2Do not press the rubber too hard so as not to damage the inside of anode-cap.
A metal fitting called the shatter-hook terminal is built into the rubber.
3Do not turn the foot of rubber over too hard.
The shatter-hook terminal will stick out or damage the rubber.
•HOW TO HANDLE AN ANODE-CAP
3When one side of the rubber cap is separated from the anode button, the anode-cap
can be removed by turning up the rubber cap and pulling it up in the direction of the
arrow c.
2Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow b.
1Turn up one side of the rubber cap in the direction indicated by the arrow a.
a
a
b
b
c
Anode button
FRAME SUB ASSY, BOTTOM REMOVAL
Slide
Screw Special (Dia. 8)
× 2
(+) TP 4 × 9
Screw Special (Dia. 8)
× 4
(+) TP 4 × 9 Screw Special (Dia. 8)
Corner Block
(+) TP 4 × 9
× 4
a)
b)
NOTE : When replacing the Frame Sub-Assy Top and Bottom, fix the original corner
block to the new part.