3-242-050-21(1)

MG-MS/FM/MW/LW

Compact Disc

Player

Installation/Connections
安裝／線路連接

MEX-5DI

Sony Corporation © 2002 Printed in Japan

3 A

SUB OUT (MONO)AUDIO OUT
FRONT

AUDIO OUT

REAR

B

BUS AUDIO IN

 

 

 

 

 

 

BUS CONTROL IN

BUS AUDIO IN

Source selector*音源選擇器*XA-C30

BUS CONTROL IN

* not supplied

非附送

1

121 mm142.5 mm

 

9.5 mm19 mm
59 mm170 mm
Dimensions include unit size, front panel and disc tray open, etc.所標出的尺寸包括主機尺寸、前面板尺寸和光碟托盤打開時的尺寸等。

2

1

2

3

 

TOP

 

456

⋅ 4

⋅ 2

789

Equipment used in illustrations (not supplied) 插圖中的裝置（非附送）
Front speaker

Power amplifier

前揚聲器功率放大器
Rear speaker

CD/MD changer

後揚聲器CD/MD 換碟機
Active subwoofer

 

有源超低音揚聲器

 

Cautions•This unit is designed for negative earth 12 V DC operation only.

•Do not get the wires under a screw, or caught in moving parts (e.g. seat railing).

•Before making connections, turn the car ignition off to avoid short circuits.

•Connect the yellow and red power input leads only after all other leads have been connected.

•Run all earth wires to a common earth point.

•Be sure to insulate any loose unconnected wires with electrical tape for safety.

Notes on the power supply cord (yellow)

•When connecting this unit in combination with other stereo components, the connected car circuit’s rating must be higher than the sum of each component’s fuse.

•When no car circuits are rated high enough, connect the unit directly to the battery.

Before installation (1)Do not install the unit where its operation interferes with driving.Example:

—Opening and closing of the front panel or disc tray interfere with operation of the gear shift.

—With the front panel open, operation of hazard lamps, switches etc., is impaired.

Parts Iist (2)The numbers in the list are keyed to those in the instructions.For the use of release key 9, see the supplied operating instructions.CautionHandle the bracket 1 carefully to avoid injuring your fingers.

TOP

Connection example (3)Note (3-A)

Be sure to connect the earth cord before connecting the amplifier.

Tip (3-B- )

For connecting two or more CD/MD changers, the source selector XA-C30 (optional) is necessary.