Recording a CD by specifying track order
—Program Edit

When programing, make sure the playing times for each side do not exceed the length of one side of the tape.

1 Load a recordable tape into the deck.
2 Program CD tracks following step 1 to 6 in “ Programing CD tracks” on page 15.
3 Press CD SYNC (or CD SYNC on the remote*).

Tape stands by for recording and CD pauses for play.

4 Press PLAY MODE/DIRECTION repeatedly to select gto record on one side. Select hor jto record on both sides.

5 Press REC z PAUSE/START (or X on the remote).

Recording starts.

Tip

If you select both sides recording and the tape reaches the end of the front side part-way through a track, the entire track is recorded again from the beginning of the reverse side.

Note

After step 3, you cannot pause a CD even if you press PAUSE X(or X on the remote).

* MHC-GS200 only

Timer-recording radio

programs

You can record a preset radio station from a specified time.

To timer-record, you must first preset the radio station (see “ Presetting radio stations” on page 20) and set the clock (see “ Setting the clock” on page 12).

1 Tune in the preset radio station (see “ Listening to the radio” on page 22).

2 Press TIMER SET.

3 Press . or > repeatedly to select
“REC SET” , then press ENTER.

“ON” appears and the hour indication flashes.

4 Set the time to start recording.

Press . or > repeatedly to set the hour, then press ENTER.

The minute indication flashes.

Press . or > repeatedly to set the minute, then press ENTER.

5 Set the time to stop recording following the procedure in step 4.

The start time appears, followed by the stop time, the preset radio station to be recorded (e.g., “ TUNER FM 5” ), then the original display appears.

6 Load a recordable tape into the deck.
7 Press ?/1 to turn off the system.

When the recording starts, the volume is reduced to minimum.

continued

Tape

25US