Hookups and Settings
Hooking Up the Recorder
Follow steps 1 to 7 to hook up and adjust the settings of the recorder.
Notes
•Plug cords securely to prevent unwanted noise.
•See the instructions supplied with the components to be connected.
•You cannot connect this recorder to a TV that does not have a video input jack.
•Be sure to disconnect the power cord of each component before connecting.
Step 1: Unpacking
Check that you have the following items:
•Audio/video cord
(phono plug ⋅ 3 y phono plug ⋅ 3) (1)
•Antenna cable (1)
•Remote commander (remote) (1)
•Size AA (R6) batteries (2)
Step 2: Connecting the Antenna Cable
Select one of the following antenna hookups. Do not connect the power cord until you reach “Connecting the Power Cord” on page 19.
If you have | Hookup |
|
|
Cable box or satellite receiver with a | |
video/audio output |
|
|
|
Cable box with an antenna output | |
only |
|
|
|
Cable without cable box, or antenna | |
only (no cable TV) |
|
|
|
Note to CATV system installer (in USA)
This reminder is provided to call the CATV system installer’s attention to Article 820- 40 of the NEC that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.
Notes
•If your antenna is a flat cable
•If you have separate cables for VHF and UHF antennas, use a UHF/VHF band mixer (not supplied) to connect the antenna to the recorder.
12