–1

–2

()
ˎ
ˎ
AF( )
ˎ
ˎ
AF/MF AF/MF
ˎ
AF/MFMF( )()
ˎ
AF( ) MF()AF
ˎ
MFMF( )MF
85mm F2.8 SAM (SAL85F28)
35mm *1 mm127.54-51*2292*219*3m 0.60.2F22mm 55mm70 52g 175*1 35mm APS-C*2 1 35mm 2 APS-C*3
ˎ
ADI ADI
ˎ
1 11 1This instruction manual explains how to use lenses. Precautions common to all lenses such as notes on use are found in the separate “Precautions before using”. Be sure to read both documents before using the lens.This lens is an A-mount lens designed for Sony α cameras.Notes on Use
When carrying a camera with the lens attached, always firmly ˎ
hold both the camera and the lens.
Do not hold the camera by the part of the lens that protrudes ˎ
when focusing.
When using this lens with an E-mount camera, attach a ˎ
separately sold Mount Adaptor. Do not attach the lens directly
to the E-mount camera or you may damage both.
Precautions for flash use
When using a built-in camera flash, always remove the lens
hood and shoot at least 1m (3.3 feet) away from your subject.
With certain combinations of lens and flash, the lens may
partially block the light of the flash, resulting in a shadow at
the bottom of the picture.
Vignetting
When using lens, the corners of the screen become darker
than the center. To reduce this phenomena (called vignetting),
close the aperture by 1 to 2 stops.
Identifying the Parts1...Focusing ring 2...Distance scale 3...Distance index 4...Lens contacts 5...Focus-mode switch 6...Mounting index Attaching and Detaching the LensTo attach the lens (See illustration .)
1 Remove the rear and front lens caps and the
camera body cap.
You can attach/detach the front lens cap in two ways, (1)
and (2). When you attach/detach the lens cap with the lens
hood attached, use method (2).
2 Align the orange index on the lens barrel with
the orange index on the camera (mounting index), then insert the lens into the camera mount and rotate it clockwise until it locks.
Do not press the lens release button on the camera when ˎ
mounting the lens.
Do not mount the lens at an angle. ˎ
To remove the lens (See illustration .)While holding down the lens release button on the camera, rotate the lens counterclockwise until it stops, then detach the lens. Attaching the Lens HoodIt is recommended that you use a lens hood to reduce flare and ensure maximum image quality.Fit the lens hood into the mount on the end of the lens barrel and rotate the lens hood clockwise until it clicks into place.
When using a built-in camera flash, remove the lens hood to ˎ
avoid blocking the flash light.
When storing, fit the lens hood onto the lens backwards. ˎ
FocusingWhen AF (Auto Focus) is selected, the camera focuses automatically.
Do not touch the rotating focusing ring while the camera is ˎ
focusing automatically.
You cannot use the camera’s direct manual focus function ˎ
with this lens. (Some cameras do not have a direct manual
focus function. If your camera has this function, this
restriction is explained in your camera’s instruction manual in
the section on focusing).
You cannot use the camera’s AF/MF button to control ˎAF/MF with this lens. (Some cameras do not have an AF/MF button. If your camera has this button, this restriction is explained in your camera’s instruction manual in the section on focusing).In MF (Manual Focus) mode, focus by rotating the focusing ring while looking through the viewfinder. (See illustration .)The focus signal in the viewfinder indicates the current ˎstate of focus.To switch between AF (Auto Focus) and MF (Manual Focus)You can switch between Auto Focus and Manual Focus by using the focus-mode switch on the lens. Be sure to set the focusing mode switch (lever) on the camera to AF.
For manual focusing, be sure to set the focus-mode switch on ˎ
the lens to MF. Rotating the focusing ring forcibly without
switching to MF may damage the focusing ring.
Shooting at infinity in MFThe focusing mechanism turns slightly past infinity to provide accurate focusing under various operating temperatures. Always confirm the image sharpness through the viewfinder, especially when the lens is focused near infinity.Specications
Name (Model name) 85mm F2.8 SAM
(SAL85F28)
Equivalent 35mm-format
focal length*1 (mm)
127.5
Lens groups-elements 4-5
Angle of view 1*229°
Angle of view 2*219°
Minimum focus*3(m (feet)) 0.6 (2.0)
Maximum magnification (×) 0.2
Minimum f-stop F22
Filter diameter (mm) 55
Dimensions (maximum
diameter × height)
(Approx., mm (in.))
70 × 52
(2 7/8 × 2 1/8)
Mass (Approx., g (oz)) 175 (6 1/8)
*1 The equivalent 35mm-format focal length shown above is
for Interchangeable Lens Digital Cameras equipped with an
APS-C sized image sensor.
*2 The angle of view 1 is for 35mm-format cameras, and the
angle of view 2 is for Interchangeable Lens Digital Cameras
equipped with an APS-C size image sensor.
*3 Minimum focus is the shortest distance from the image
sensor to the subject.
This lens is equipped with a distance encoder. The distance ˎ
encoder allows more accurate measurement (ADI) by using an
ADI-compatible flash.
Depending on the lens mechanism, the focal length may ˎ
change with any change of the shooting distance. The focal
length assumes the lens is focused at infinity.
Included itemsLens (1), Front lens cap (1), Rear lens cap (1), Lens hood (1), Set of printed documentationDesign and specifications are subject to change without notice.4-199-189-01(1)©2010 Sony CorporationPrinted in Japan/ Interchangeable Lens/ Objectif interchangeable/
/Operating Instructions/Mode demploi/
Manual de instrucciones/
A
ˎ
ˎ
E
ˎ
E
1
1 2 1 2 34 56
()

1

1222

2

ˎ
ˎ
is a trademark of Sony Corporation.Cette notice d’emploi explique comment se servir des objectifs.Les précautions communes à tous les objectifs, par exemple les remarques sur l’emploi, se trouvent sur la feuille « Précautions avant toute utilisation ». Veuillez lire les deux documents avant d’utiliser l’objectif.Cet objectif est un objectif à monture A conçu pour les appareils photo Sony α.Remarques sur l’emploi
Lorsque vous portez un appareil photo avec l’objectif dessus, ˎ
tenez toujours fermement l’appareil photo et l’objectif.
Ne tenez pas l’appareil photo par la partie de l’objectif qui ˎ
ressort lors de la mise au point.
Lorsque vous utilisez cet objectif avec un appareil photo ˎ
à monture E, rattachez toujours un adaptateur pour
monture d’objectif vendu séparément. Ne fixez pas l’objectif
directement sur l’appareil photo à monture E car vous
risqueriez d’endommager l’un et l’autre.
Précautions concernant l’emploi du flash
Lorsque vous utilisez le flash intégré de l’appareil photo,
retirez toujours le parasoleil et prenez vos photos à au moins
1 m (3,3 pieds) du sujet. Associé à certains types de flash,
l’objectif peut bloquer partiellement la lumière du flash et
produire un ombre au bas de l’image.
Vignetage
Lorsqu’un objectif est utilisé, les coins de l’écran deviennent
plus sombres que le centre. Pour réduire ce phénomène
(appelé vignetage), fermez l’ouverture de 1 ou 2 crans.
Noms des éléments 1...Bague de mise au point 2...Échelle de mise au point 3...Indice de distance 4...Contacts de l’objectif 5...Commutateur de mode de mise au point6...Repère de montage Pose et dépose de l’objectif Pour poser l’objectif (Voir l’illustration .)
1 Déposez les capuchons d’objectif avant et
arrière et le capuchon de l’appareil photo.
Vous pouvez poser et déposer le capuchon d’objectif
avant de deux façons, (1) et (2). Si vous posez/déposez le
capuchon d’objectif avec le parasoleil, utilisez la méthode
(2).
2 Alignez le repère orange du barillet d’objectif
sur le repère orange de l’appareil photo (repère de montage), puis posez l’objectif sur la monture de l’appareil photo et tournez-le dans le sens horaire de sorte qu’il s’encliquette.
N’appuyez pas sur le bouton de libération de l’objectif sur ˎ
l’appareil photo lorsque vous posez l’objectif.
Ne posez pas l’objectif de biais. ˎ
Pour déposer l’objectif (Voir l’illustration .) Tout en appuyant sur le bouton de libération de l’objectif sur l’appareil photo, tournez l’objectif dans le sens antihoraire jusqu’à l’arrêt, puis déposez l’objectif. Fixation du parasoleil Il est conseillé d’utiliser un parasoleil pour réduire la lumière parasite et obtenir la meilleure image possible.Emboîtez le parasoleil dans la monture au bout du barillet d’objectif et tournez le parasoleil dans le sens horaire de sorte qu’il s’encliquette.
Si vous utilisez le flash intégré de l’appareil photo, retirez le ˎ
parasoleil pour éviter de bloquer la lumière du flash.
Pour ranger le parasoleil, insérez-le à l’arrière de l’objectif. ˎ
Mise au point Lorsque AF (Mise au point automatique) est sélectionné, l’appareil photo fait automatiquement la mise au point.
Ne touchez pas la bague de mise au point lorsqu’elle tourne ˎ
pendant la mise au point automatique.
Vous ne pouvez pas utiliser la mise au point manuelle directe ˎ
de cet appareil photo avec cet objectif. (Certains appareils
photo ne présentent pas de mise au point manuelle directe. Si
votre appareil photo présente cette fonction, cette restriction
est expliquée dans le mode d’emploi de votre appareil photo
dans la partie concernant la mise au point.)
Vous ne pouvez pas utiliser la touche AF/MF de l’appareil ˎ
photo pour contrôler la mise au point AF/MF avec cet objectif.
(Certains appareils photo n’ont pas de touche AF/MF. Si votre
appareil photo a cette touche, cette restriction est expliquée
dans le mode d’emploi de votre appareil photo dans la partie
concernant la mise au point.)
En mode MF (Mise au point manuelle), faites la mise au point en tournant la bague de mise au point et regardant dans le viseur. (Voir l’illustration .)
Le signal de mise au point dans le viseur indique l’état actuel ˎ
de la mise au point.
Pour commuter entre AF (Mise au point automatique) et MF (Mise au point manuelle)
Vous pouvez commuter entre la mise au point automatique et
la mise au point manuelle à l’aide du commutateur de mode de
mise au point sur l’objectif. Veillez à mettre le commutateur de
mode de mise au point (levier) sur l’appareil photo sur AF.
Pour la mise au point manuelle, veillez à mettre le ˎ
commutateur de mode de mise au point sur l’objectif sur MF.
La bague de mise au point peut être endommagée si vous
essayez de la tourner de force alors que le commutateur n’est
pas en position MF.
Prise de vue à l’infini en mode MF Le mécanisme de mise au point dépasse légèrement l’infini pour atteindre une plus grande netteté à diverses températures de fonctionnement. Vérifiez toujours la netteté de l’image dans le viseur, notamment lorsque le réglage de l’objectif est proche de l’infini.(Suite à la page arrière)SAL85F28
85mm F2.8 SAM
.5
8 10 20 50 ft
m
2 3 5 12
3142
65
.5
8 10 20 50 ft
m
2 3 5 12
(1) (2)A-mount