37
Preparing the camera
If dust or debris enters the camera and adheres to the image sensor (the part
that acts as the film), it may appear as dark spots on the photo image,
depending on the shooting environment. If there is dust on the image
sensor, clean the image sensor following the steps below.
Notes
•Cleaning cann ot be performed when the battery level is 50% or less.
•The camera starts beeping if the battery pack becomes low during cleaning. Stop
cleaning immediately and turn the camera off. The use of an AC-PW20 AC Adaptor
(sold separately) is recommended.
•The cleaning should be completed quickly.
•Do not use a spray blower becaus e it may scatter water droplets inside the camera
body.
To clean the image sensor automatically using the cleaning mode of the
camera

Cleaning the image sensor

1Confirm that the battery is fully charged (page23).
2Press the MENU button, then
select 2 with b/B on the
control button.
MENU button
3Select [Cleaning Mode] with v/V,
then press the center of the
control button.