Displays the date and time set on your computer. When you want to synchronize the camera’s date and time with the date and time setting of the computer, operate as follows:
Click Time Synchronization, and “Applied, OK” window appears. Click OK to change the date and time on
When you want to set the camera’s date and time manually, operate as follows:
Type the date and time you want to set for the camera and click Time Synchronization. “Applied, OK” window appears. Click OK to change the date and time on
When you want to set the camera’s date and time to the time in the area where the camera is installed, select the camera location from the
Type the maximum number of clients (1 to 100) that can log in this camera at the same time.
Factory DefaultResets to the factory settings.
Click Factory Setting, and “All configuration information will be initialized as factory setting. Are you sure?” appears. Click OK to reset to the factory settings.
Note
The following settings cannot be reset with this operation: Date and time on the System Setting page, and IP Address, Subnet Mask, Broadcast Address and Default Gateway on the Network Setting page.
RebootReboots the camera.
Click Reboot, and “The
Note
If the setting page cannot be displayed after you have clicked Reboot, refresh the Web browser window. The Menu page is displayed.
Apply/Cancel/HelpSetting the User
— User Setting Page
When you click User in the menu section, the User Setting page appears.
Use this page to set the user names and passwords of Administrator and up to five kinds of users (User 1 to User 5), and the access right of each user.
User AccountType a user name up to 9 characters.
PasswordType a password up to 9 characters.
To confirm the password, type the same characters as those you typed in the Password box.
If you
Select the access right for each user from the
None
Allows only monitoring of the camera image on the viewer page, including the operations of the monitor image.
Sensor
Allows monitoring of the camera image and alarm output by clicking Sensor 1 and Sensor 2 on the viewer page.
Setting the User — User Setting Page | 15 |
|
|