Others
Assigning the IP Address to the Camera Using ARP CommandsThis section explains how to assign an IP address to the camera using ARP (Address Resolution Protocol) commands without using the supplied setup program.
For the use of the setup program, see “Assigning the IP Address to the Camera” in the supplied Installation Manual.
Assigning the IP Address
Open a DOS window and enter the IP address and the MAC address of the camera you want to assign a new IP address to, using the following commands.
Arp
Example:
Arp
Ping
Note
For the details of the use of the ARP commands, refer to the ARP command help. To display the help, type “arp
To enable the DHCP server
If you want to enable the DHCP server when you have assigned the IP address using ARP commands, proceed as follows:
1Access the camera from the browser, then set the DHCP Client Protocol menu to Enable on the Network Setting page (see page 17).
2Clear the ARP cache by using the Arp- d command or restarting the computer.
Confirming the Setup
If the IP address is successfully assigned, a message similar to the following will appear on the screen.
Request timed out
:
Request timed out
Reply from 192.168.0.100: bytes=32 time=2ms TTL=255
Reply from 192.168.0.100: bytes=32 time=2ms TTL=255
Ping statistics for 192.168.0.100:
Packets: Sent = 4, Received = 4, Lost = 0 (0% loss), Approximate round trip times in milliseconds;
Minimum = 1ms, Maximum = 2ms, Average = 1ms
28 Assigning the IP Address to the Camera Using ARP Commands