Sony VPL-ES1 Warning Messages, Others, Symptom, Symptom, Message, Remote Commander, Cause and Remedy, Cause and Remedy, Meaning and Remedy

Remote Commander

Symptom	Cause and Remedy
The Remote Commander	• The Remote Commander batteries are dead.
does not work.	c Replace with a new battery (page 14).

Others

Symptom	Cause and Remedy
The LAMP/COVER	• The lamp cover is detached.
indicator flashes.	c Attach the cover securely (see page 40).
	• The lens protector does not open due to a problem.
	c Consult with qualified Sony personnel. If it is necessary to use
	the projector in case of emergency, use it in the emergency mode
	(see page 46).
The LAMP/COVER	• The lamp has reached the end of its life.
indicator lights up.	c Replace the lamp (see page 39).
	• The lamp becomes a high temperature.
	c Wait for 90 seconds to cool down the lamp and turn on the
	power again (see page 27).
The TEMP/FAN indicator	• The fan is broken.
flashes.	c Consult with qualified Sony personnel.
The TEMP/FAN indicator	• The internal temperature is unusually high.
lights up.	c Check to see if anything is blocking the ventilation holes.
	c Check to see whether or not the projector is being used at high
	altitudes.
Both the LAMP/COVER	• The electrical system breaks down.
and TEMP/FAN indicators	c Consult with qualified Sony personnel.
light up.

Warning Messages

Use the list below to check the meaning of the messages displayed on the screen.

Message	Meaning and Remedy
High temp.!	• Internal temperature is too high.
Probably use in high	c When using the projector at an altitude of 1.500 m or higher, set
altitude. Switch to high	the setting of “High Altitude Mode” in the INSTALL SETTING
altitude mode on? Yes R	menu to on. (see page 37)
No r	• If this message appers on the screen when using the projector at
	normal altitudes, check to see if anything is blocking the
	ventilation holes (exhaust).
High temp.!	• Internal temperature is too high.
Lamp off in 1 min.	c Turn off the power.
	c Check to see if anything is blocking the ventilation holes.
Frequency is out of range!	• This input signal cannot be projected as the frequency is out of the
	acceptable range of the projector.
	c Input a signal that is within the range of the frequency.
	• The resolution setting of the output signal of a computer is too
	high.
	c Set the setting of output to SVGA (see page 17).

GB 44 Troubleshooting