14 Projecting an Image
Adjusting the tilt of the projector
with the adjusters
When the projector is installed on an uneven
surface, you can adjust using the adjusters.
To correct any trapezoidal distortion of the
projected image, use the Keystone feature
(page5, 26).
And you can also broaden the adjustment
range by removing the nuts from the
adjuster.
• Be careful no t to let the projector down on
your fingers.
• Do not push har d on the top of the projector
with the adjuster extended. It may cause a
malfunction.
• Since the Keystone adjustment is an
electronic correction, the image may be
deteriorated.
Displaying a pattern for adjusting
an image
You can display a pattern for adjusting the
projected image with the PATTERN key on
the Remote Commander. Press the
PATTERN key again to restore the previous
image.
1Press the ?/1 key on the main unit or
1 key on the Remote Commander.
The message appears if you press the ?/
1 key on the main unit. Press it again
according to the message.
The fan continues to run for a while to
reduce internal heat.
2Unplug the AC power cord from the
wall outlet.
You may unplug the AC power cord
before the fan stops.
To move the projector just after turning it
off, be sure to wait until the fan stops
before unplugging the AC power cord.
Unplugging the AC power cord before the
fan stops may cause a malfunction.
To erase the confirmation message
The message disappears if you press any key
other than the ?/1 key on the main unit or 1
key on the Remote Commander, or if you do
not press any key for a while.
To turn off the power with the key
on the main unit without a
confirmation message being
displayed
Hold the ?/1 key on the main unit pressed
for a few seconds.
Notes
Turning Off the Power
Note