Sony XR-CA360EE manual

3-257-690-11(1)

FM/AM

Cassette

Car Stereo

Installation/Connections

Установка/Подсоединение

XR-CA360EE

BUS AUDIO INBUS CONTROL INAUDIO OUTREAR

BUS AUDIO IN

Source selector*Селектор источника*XA-CA30

BUS CONTROL IN

*not supplied

не прилагается

12 3

45 6

Cautions

•This unit is designed for negative earth 12 V DC operation only.

•Do not get the wires under a screw, or caught in moving parts (e.g. seat railing).

•Before making connections, turn the car ignition off to avoid short circuits.

•Connect the power connecting cord 6 to the unit and speakers before connecting it to the auxiliary power connector.

•Run all earth wires to a common earth point.

•Be sure to insulate any loose unconnected wires with electrical tape for safety.

Notes on the power supply cord (yellow)

•When connecting this unit in combination with other stereo components, the connected car circuit’s rating must be higher than the sum of each component’s fuse.

•When no car circuits are rated high enough, connect the unit directly to the battery.

Note

Before installing, make sure that the catches on both sides of the bracket 1 are bent inwards 2 mm. If the catches are straight or bent outwards, the unit will not be installed securely and may spring out.

Connection example (2)

Notes (2-B- )

•Be sure to connect the earth cord before connecting the amplifier.

•If you connect an optional power amplifier and do not use the built-in amplifier, the beep sound will be deactivated.

Tip (2-B- )

For connecting two or more CD/MD changers, the source selector XA-C30 (optional) is necessary.

Connection diagram (3)

ATo AMP REMOTE IN of an optional power amplifier

This connection is only for amplifiers. Connecting any other system may damage the unit.

⋅ 2

⋅ 4

Equipment used in illustrations (not supplied)

Аппаратура, фигурирующая в иллюстрациях (не прилагается)

Front speaker

Parts Iist (1)

•The numbers in the list are keyed to those in the instructions.

•The bracket 1 and the protection collar 4 are attached to the unit before shipping. Before mounting the unit, use the release keys 7 to remove the bracket 1 and the protection collar

4 from the unit. For details, see “Removing

the protection collar and the bracket (4)” on

the reverse side of the sheet.

•Keep the release keys 7 for future use as

they are also necessary if you remove the

Warning

If you have a power aerial without a relay box, connecting this unit with the power connecting cord 6 may damage the aerial.

Notes on the control leads

• The power aerial control lead (blue) supplies +12 V

DC when you turn on the tuner.

• When your car has built-in FM/AM aerial in the

rear/side glass, connect the power aerial control

lead (blue) or the accessory power input lead (red)

to the power terminal of the existing aerial

booster. For details, consult your dealer.

Передний

Power amplifierУсилитель

unit from your car.

• A power aerial without a relay box cannot be used

with this unit.

громкоговоритель

Rear speaker	CD/MD changer
Задний	Проигрыватель компaкт-диcков/
громкоговоритель	мини-диcков

	Caution	Memory hold connection
	Handle the bracket 1 carefully to avoid injuring	Memory hold connection
	Handle the bracket 1 carefully to avoid injuring	When the yellow power input lead is connected,
	your fingers.	power will always be supplied to the memory circuit
		even when the ignition switch is turned off.

Catch