Precautions
On safety•As the laser beam used in the CD player section is harmful to the eyes, do not attempt to disassemble the casing. Refer servicing to qualified personnel only.
•Should any solid object or liquid fall into the player, unplug the player, and have it checked by qualified personnel before operating it any further.
•Discs with
•Clean the cabinet, panel and controls with a soft cloth slightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder, or solvent, such as alcohol or benzine.
On power sources• For AC operation, use the supplied AC power adaptor; do not use any other type.
•The player is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the player itself has been turned off.
•Unplug the player from the wall outlet when it is not to be used for an extended period of time.
•For battery operation, use six size D (R20) batteries.
•When the batteries are not to be used, remove them to avoid damage that can be caused by battery leakage or corrosion.
•The nameplate indicating operating voltage, etc. is located at the bottom.
On placement• Do not leave the player in a location near |
heat sources, or in a place subject to direct |
sunlight, excessive dust or mechanical |
•If the player is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lenses inside the CD player section. Should this occur, the player will not operate properly. In this case, remove the CD and wait about an hour for the moisture to evaporate.
Notes on CDs•Before playing, clean the CD with a cleaning cloth. Wipe the CD from the center out.
•Do not use solvents such as benzine, thinner, commercially available cleaners or
•Do not expose the CD to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight as there can be a considerable rise in temperature inside the car.
•Do not stick paper or sticker on the CD, nor scratch the surface of the CD.
•After playing, store the CD in its case.
If there is a scratch, dirt or fingerprints on the CD, it may cause tracking error.
AboutThis player can play
*
The CD does not play or “no dISC” lights in the display even when a CD is in place.
•Place the CD with the label surface up.
•Clean the CD.
•Take out the CD and leave the CD compartment open for about an hour to dry moisture condensation.
•The
•There is a problem with the quality of the CD-
•Replace all the batteries with new ones if they are weak.
The sound drops out.•Reduce the volume.
•Clean the CD, or replace it if the CD is badly damaged.
•Place the player in a location free from vibration.
•Clean the lens with a commercially available blower.
•The sound may drop out or noise may be heard when using poor quality
•Place the player on a level surface and open/ close the lid.
LensRadioReception is poor.• Reorient the antenna to improve FM |
reception. |
Specifications
AUDIO POWER SPECIFICATIONSPOWER OUTPUT AND TOTAL HARMONIC DISTORTION
With
System
Compact disc digital audio system Laser diode properties
Material: GaAlAs
Wave length: 780 nm
Emission duration: Continuous
Laser output: Less than 44.6 µW
(This output is the value measured at a distance of about 200 mm from the objective lens surface on the optical
Spindle speed
200 r/min (rpm) to 500 r/min (rpm) (CLV)
Number of channels 2
Frequency response
20 - 20 000 Hz
Below measurable limit
Radio sectionFrequency range
FM: 87.5 - 108 MHz
AM: 530 - 1 710 kHz
Antennas
FM: Telescopic antenna
AM:
Speaker
Full range: 10 cm dia., 3.2 ohms, cone type (2) Outputs
Headphones jack (stereo minijack)
For 16 - 64 ohms impedance headphones
Personal
Audio
System
Operating Instructions
ZS-X1
©2003 Sony Corporation
Printed in China
WARNING
To prevent fire or shock hazard, do not expose the player to rain or moisture.This symbol is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
CAUTIONThe use of optical instruments with this product will increase eye hazard.
WARNINGDo not install the appliance in a confined space, such as a bookcase or
To prevent fire or shock hazard, do not place objects filled with liquids, such as vases, on the appliance.
For customers in CanadaTo prevent electric shock, match wide blade of plug to wide slot, fully insert.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/ TV technician for help.
This class B digital device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment.
The model number is located at the bottom and the serial number is located in the battery compartment.
Record the serial number in the space provided below. Refer to them whenever you call upon your Sony dealer regarding this product. Model No.
Serial No.
For customers in the USA
Please register this product on line at http://www.sony.com/productregistration.
Proper registration will enable us to send you periodic mailings about new product, services and other important announcements. Registering your product will also allow us to contact you in the unlikely event that the product needs adjustment or modification. Thank you.
shock. |
• Do not place the player on an inclined or |
unstable place. |
• Do not place anything within 10 mm of |
the side of the cabinet. The ventilation |
holes must be unobstructed for the player |
to operate properly and prolong the life of |
its components. |
• If the player is left in a car parked in the |
sun, be sure to choose a location in the car |
where the player will not be subjected to |
the direct rays of the sun. |
• Since a strong magnet is used for the |
speakers, keep personal credit cards using |
magnetic coding or |
away from the player to prevent possible |
This product is designed to play back discs that conform to the Compact Disc (CD) standard. Recently, various music discs encoded with copyright protection technologies are marketed by some record companies. Please be aware that among those discs, there are some that do not conform to the CD standard and may not be playable by this product.
If you have any questions or problems concerning your player, please consult your nearest Sony dealer.
•Reorient the player itself to improve AM reception.
Power output
2.3W + 2.3 W (at 3.2 ohms, 10% harmonic distortion)
Power requirements
DC IN 9V jack accepts:
Supplied AC power adaptor for use with 120V AC, 60 Hz
9 V DC, 6 size D (R20) batteries Battery life
For personal audio system:
CD playback
Sony R20P: approx. 7.5 h
Sony alkaline LR20: approx. 14 h
Radio play
Sony R20P: approx. 11 h
Power Sources
2 to a wall outlet | B |
damage from the magnet. |
This product is not meant to be immersed in water or come in continuous contact with water.
•Before opening or shutting the CD compartment or battery compartment lid, be sure to wipe off water, dust or sand on the outside of the player.
•Water in the headphones jack/DC IN jack may cause rusting. Cover the jacks with the attached rubber cap when the jacks are not used.
•If the player is splashed with salt water, wipe clean with a damp cloth, then dry with a soft dry cloth. Do not wash under running water; do not use soap or detergent; do not dry with an electric hair dryer.
•The supplied AC power adaptor is not water resistant. To prevent shock hazard, avoid using the player near water during AC operation.
Troubleshooting
GeneralThe power does not come on.•Make sure the batteries are inserted correctly.
•Replace all the batteries with new ones if they are weak.
The power is not on, and "bAttErY" and “Error” are displayed alternately.
•Make sure the batteries are inserted correctly.
•Replace all the batteries with new ones if they are weak.
There is no audio.•Adjust the volume.
•Unplug the headphones when listening through speakers.
Noise is heard.•Someone is using a portable telephone or other equipment that emits radio waves near the player. tMove the portable telephone, etc., away from the player.
•Replace all the batteries with new ones if they are weak.
•Move the player away from the TV.
The picture of your TV becomes unstable.•If you are listening to an FM program near the TV with an indoor antenna, move the player away from the TV.
After trying the above remedies, if you still have problems, unplug the AC adaptor and remove all the batteries. After all the indications in the display disappear, plug the power cord and insert the batteries again. If the problem persists, please consult your nearest Sony dealer.
Sony alkaline LR20: approx. 24 h
Dimensions
Approx. 430 ⋅ 169 ⋅ 288 mm (w/h/d)
(17 ⋅ 6 3⁄4 ⋅ 11 3⁄8 inches) (incl. projecting parts) Mass
Approx. 3.5 kg (7 lb. 11 oz) (incl. batteries) Supplied accessory
AC power adaptor(1)
Design and specifications are subject to change without notice.
Optional accessoriesSony MDR headphone series
A1 to DC IN 9V
Connect the AC power adaptor A or insert six size D (R20) batteries (not supplied) into the battery compartment B.
Notes•Replace the batteries when the OPR/BATT indicator dims or when the player stops operating. Replace all the batteries with new ones.
•To use the player on batteries, disconnect the AC power adaptor from the player.