Calibration | Explanation |
type |
|
|
|
ENGINEER | Sets the frequency |
| characteristics to a set that |
| matches that of the Sony |
| listening room standard. |
|
|
FULL FLAT | Makes the measurement of |
| frequency from each |
| speaker flat. |
Measurement starts in five seconds. A countdown appears on the display.
While the time is counting down, stand away from the measurement area to avoid measurement error.
7 Measurement starts.The measurement process will take approximately 10 seconds. Wait until the measurement process completes.
Tip
When special speakers, such as dipole speakers, are used, the measurements may not be performed correctly or auto calibration cannot be performed.
To cancel auto calibrationAuto calibration is cancelled when you change the volume, change the input source, change the speaker selection, press MUTING, or connect headphones.
When the measurement ends, a beep sounds and the measurement result appears on the display.
Measurement Display | Explanation | |
result |
|
|
|
|
|
When the | COMPLETE | Proceed to step |
measurement |
| 2. |
process |
|
|
completes |
|
|
properly |
|
|
|
|
|
When the | ERROR | See “When |
measurement | CODE XX | |
process fails |
| appear” (page |
|
| 14). |
Item | Explanation |
RETRY | |
| calibration. |
|
|
SAVE EXIT | Saves the measurement |
| results and exits the setting |
| process. |
|
|
WRN CHECK | Displays a warning |
| concerning the |
| measurement results. See |
| |
| |
|
|
EXIT | Exits the setting process |
| without saving the |
| measurement results. |
|
|
When error codes appear Try the remedies and
Error code Cause and remedies
CODE 31 SPEAKERS (OFF/A/B/A+B) is set to OFF. Select A or B and re- perform the auto calibration.
When using a
14GB