SpeakerCraft BassX-W10 owner manual Troubleshooting, Problem

Page 10 BassX-W10 Owner’s Manual

TROUBLESHOOTING

The BassX-W10 Subwoofer System is designed to function trouble-free. Most problems occur because of operating errors. If you have a problem, please check the troubleshooting list first. If the problem persists, contact Tech Support at 1-800-448-0976 or e-mail us at techsupport@speakercraft.com.

The Problem

No sound is heard.

A hum or buzzing sound is heard.

The amplifier will not turn on.

The Protection Circuit cuts in momentarily and then turns off.

The Protection Circuit cuts in and does not turn off.

Possible Causes and Solutions

Audio cable to the amplifier is not connected properly or the cable is bad. Use another cable that you know is good.

Check all speaker wire connections and plugs.

Rear Volume Limit Control is set to 1/2 way or 12 O'clock

The sound may be caused by a ground loop in the system. Try to eliminate this by reversing the AC plugs of other compo- nents in the system.

Try plugging the amplifier into another outlet.

Other causes may include faulty cables.

The amplifier must be plugged into a live outlet. The power switch on the rear panel must be on. A signal must be playing into the input jacks, or speaker inputs.

The circuitry in the amplifier has detected that the amplifier or subwoofer is in danger of overheating. Normally, this would happen infrequently and momentarily. If it persists, the amplifier may not be ventilated appropriately.

Move the amplifier to a better ventilated and/or cooler loca- tion. NOTE: The amplifier may feel cool at the top, but still be overheating. Do not use the temperature at the top of the cabinet as a gauge for amplifier temperature.

There may be a fault in the wiring, the speaker, or the ampli- fier. Turn the power switch off and then on again. If the ampli- fier immediately returns to the Protection mode, turn it off and check all of the wiring, including all connections at the amplifier, at the subwoofer, and any connections made to the wall.

SPECIFICATIONS – BassX-W10 Subwoofer & Baffle

Driver:	10" Long Throw Woofer, Treated Pulp Cone with Butyl Rubber Surround
Type:	Cast frame reverse magnet
Impedance:	4 ohms
SPL:	86 dB
Frequency Response:	20 Hz
Baffle & Grille Color:	White
Cut-Out Dimensions:	W 111⁄4" x H 111⁄4" (for baffle)
Dimensions:	W 131⁄32" x H 131⁄32" (includes subwoofer & baffle)
Weight:	6 lbs. (subwoofer only)