Installation

Step 3: Connect Drain Hose to Drain Receptacle

Remove the drain hose from its shipping position on the rear of the washer by unhooking the hose from the retainer clamp and by removing shipping tape.

Find the instructions, on the following pages, that are appropriate for your type of drain receptacle (standpipe, sink, wall, or laundry tub). Follow these instructions to properly install the drain hose.

IMPORTANT: Drain receptacle must be capable of handling a minimum of 1-1/4 inch (3.2 cm) outside diameter drain hose.

1

2

3

FLW1992N

1

FLW1991N

1Retainer Clamp

Figure 5

Standpipe Installation

Place the drain hose into the standpipe.

Remove the beaded tie-down strap from accessories bag and place around standpipe and drain hose and tighten strap to hold hose to standpipe. This will prevent the drain hose from dislodging from drain receptacle during use.

124 in. to 36 in. (91.44 cm recommended height)

2Standpipe – 2 in. (5.08 cm) or 1-1/2 in. (4 cm)

3Beaded Tie-Down Strap

Figure 6

Sink Installation

For this type of installation, use the beaded tie-down strap (supplied in accessories bag) or use a large wire tie (available from your local hardware store), and secure the drain hose to the cabinet top hinge (refer to Figure 7). This will prevent the drain hose from dislodging during use.

1

2

FLW1993N

1Drain Hose

2Tie-Down Strap (Wire tie or tape if necessary)

Figure 7

8

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

801516