Speed Queen H370I Step 5: Remove the Shock Sleeves and Shipping Brace, Step 6: Wipe Out Inside of Washer Drum, Step 7: Plug In the Washer, Reinstall front access panel

Step 5: Remove the Shock Sleeves and Shipping Brace

Remove front access panel by removing the two screws.

Remove bolts and lockwashers from shipping brace with 9/16 in. wrench and remove brace. Remove shock sleeves by pulling on the yellow rope.

Remove label from front side of front access panel and place on backside of front access panel.

NOTE: The shipping brace, bolts, lockwashers and shock sleeves should be saved and MUST be reinstalled whenever the unit is moved more than four feet. Do not lift or transport unit from front or without shipping materials installed.

Store the shipping materials in the bag provided in the accessories bag. Save materials for use whenever the unit is moved.

NOTE: The shipping materials MUST be reinstalled whenever the unit is moved. Refer to Moving Unit to a New Location section for proper instructions on reinstalling the shipping materials.

Reinstall front access panel.

2 4

H336I

1Shock Sleeves

2Motor Mount

3Bolts and Lockwashers

4Hooked End of Shipping Brace

Figure 11

Installation

Step 6: Wipe Out Inside of Washer Drum

Before using the washer for the first time, use an all- purpose cleaner, or a detergent and water solution, and a damp cloth to remove shipping dust from inside the drum.

H337I

Figure 12

Step 7: Plug In the Washer

Refer to section on Electrical Requirements and connect the washer to an electrical power source.

D254I

Plug cord into separately fused 15 Amp circuit.

D254I

Figure 13

801516