Backlight
The second option allows to set the backlight. Operates in similar mode as Contrast.
13.0.2 Cartridges
To check the
Background ROM
To test the WorldWideBackground. If there is not a malfunction, the code of the Background and the message "OK" are shown, but if the Background is defective the message "Faulty" is shown.
C-CARD Test
To test the
1.if there is a
2.if there is a
3.if there is not any
4.if there is a User
Indicates if there is a malfunction in the connector.
13.0.3 Serial Ports
If you are having problems receiving data from the
Change Parameters
To change the parameters of the serial interface. This menu allows to select the Port (Signal Source) between PORT 1 or PORT 2, the Baud Rate between 300, 1200, 2400, 4800 or 9600, the Data Bits (Word Length) between 7 or 8, the Parity between even, odd or none, the Stop Bits between 1 or 2. Default settings are: Port = PORT 1, Baud Rate = 4800, Data Bits = 8, Parity = none, Stop Bits = 1.
Input Data Display
To allow the chartplotter to act as a computer terminal and display the incoming data exactly as it is received.
If the data displayed on the screen is unrecognizable, you may have selected the wrong input parameters for your particular receiver, for example, Baud Rate 9600 instead of Baud Rate 4800. Check your receiver manual to be sure that you have selected the proper parameter. If the screen is blank, you may have a broken connection, and no data is being received or you may have connected the device to the other input port.
Use [ZOOM IN] to stop (or continue after pause) data displaying, [ENTER] to show data in hex or ASCII mode (normal or small) and [CLEAR] to exit.
13.0.4 Modem test
Checks the Modem connections (to be used only if the
Page 74 |
| GPS chartplotters |
|