4 APPEARANCE AND NOMENCLATURE
Housed unit TCP100/2000 series
3 4
5
6 |
|
|
| 0 | A |
9 |
| 0 |
|
| |
| 8 | 8 |
| 7 | 7 |
2 |
|
|
1 | [TCP100] | [TCP2000 back] |
1 Switch Cover | This cover protects the power switch of the system. | |
| Push to open and close. |
|
2 Power Switch | This switch turns the power of the system ON/OFF. | |
3 POWER LED | This LED indicates that the power of the system is on. | |
4 READY LED | This LED indicates that the card processing is ready. | |
5 OK LED | This LED indicates that the card has been processed | |
| without error. |
|
6 ERROR LED | This LED indicates that the card has not been read due | |
| to an error e.g. jamming of the card in the reader/writer. | |
7RS232C Serial Connector This connector interfaces the connection between host
| computers and the reader/writer. |
8 AC Power Inlet | Connect this inlet to the power source with the attached |
| AC power cable. |
9 Cleaning Button | Push this button under the power ON condition, then |
| insert the cleaning card which is soaked with the clean- |
| ing liquid. |
0 Modular Connector | This interfaces the connection between MCD2000 (Star |
| original numerical key pad). |
AInterface convert switch This switch changes the available interface : RS232C (right side) or modular connector (left side).
IMPORTANT!
A three terminal earth grounded power supply cable is attached to TCP100/ 2000 housed unit. For safety, do not remove the ground pin.
6
