English
|
| 1 |
3 |
| KN |
| 2 | 151BA008 |
|
|
NPress down the throttle trigger lockout (1) and squeeze the throttle trigger (2) at the same time – hold both levers in that position.
NMove the Master Control lever (3) to nand hold it there.
NNow release the throttle trigger, Master Control and throttle trigger lockout in that order. This is the starting throttle position.
if the engine is cold
4 KN151BA009
NMove the choke lever (4) to l.
If the engine is warm
4 KN151BA010
NSet the choke lever (4) to j . Also use this position if the engine has been running but is still cold.
161BA011 KN
NPlace your saw on the ground. Make sure you have a firm footing – check that the chain is not touching any object or the ground.
Bystanders must be well clear of the general work area of the saw.
NHold the saw firmly on the ground with your left hand on the front handle – your thumb should be under the handle.
NPut your right foot into the rear handle and press down.
151BA012 KN
Alternative method of starting:
NHold the rear handle tightly between your legs, just above the knees.
NHold the front handle firmly with your left hand – your thumb should be under the handle.
NPull the starter grip slowly and steadily with your right hand and push down the front handle at the same time. Do not pull out the starter rope all the way – it might otherwise break.
NDo not let the starter grip snap back. Guide it slowly back into the housing so that the starter rope can rewind properly.
32
MS 192 C