English
The rewind spring may pop out and uncoil during this operation –
take care to avoid the risk of injury.
NUse a screwdriver to pry the rope out of the starter grip.
NRemove the remaining rope from the rotor and starter grip.
213BA019 KN
NThread the new rope through the top of the starter grip.
5 | 6 |
7
213BA020 KN
NThread the end of the rope through the top of the guide bushing (5) and rope rotor (6) and secure it with a simple overhand knot.
NCoat the rope rotor bearing bore with
NSlip the rotor over the starter post (7) – turn it back and forth to engage the anchor loop of the rewind spring.
2
3
4 | 4 | |
001BA096 KN | ||
|
NFit the pawls (4) in the rotor and fit the washer (3) on the starter post.
NUse a screwdriver or suitable pliers to install the spring clip (2) on the starter post and engage it on the pawls' pegs – the spring clip must point clockwise as shown in the illustration.
Tension the rewind spring.
213BA021 KN
NMake a loop in the unwound starter rope and use it to turn the rope rotor six full revolutions in the direction of the arrow.
NHold the rotor steady. Pull out and straighten the twisted rope.
NLet go of the rotor.
NRelease the rope slowly so that it winds onto the rotor.
42 | MS 441 |