Before first use
Remove any adhesive stickers, plastic covers
or cardboard sleeves from the soleplate.
Ensure that all adhesive is removed by rubbing
the soleplate with a cloth dampened with
methylated spirits.
Fill the water tank and empty the water. This
will rinse out any foreign particles remaining
in the water tank from the manufacturing
process.
NOTE: When turned on for the first time,
your new iron may give off vapours for up
to 10 minutes. This is due to the initial
heating of the materials used. It is safe, not
detrimental to the performance of the iron,
and will not reoccur.
Filling the iron with water
Before filling the iron with water ensure the
power is turned off and the plug is removed
from the power outlet. The iron c an be filled
with water while it is hot.
Place the iron on its heel and open the water
inlet cover.
Slowly pour water into the water inlet until
the maximum water level is reached. Do not
exceed the maximum water level indicator.
Push the water inlet cover firmly to close.
NOTE: The special soleplate design allows you
to use tap water with your Verve iron without
affecting the steam performance. However in
very hard water areas, Sunbeam recommends
the use of distilled water, or water which has
been demineralised.
For best performance, we recommend the use
of Sunbeam Water Demineraliser, available
from selected retailers. This will produce up to
30 litres of demineralised water.
Do not fill the iron with fabric conditioner,
starches or any other solution as these w ill
damage the steam mechanism. Do not use
contaminated water.
Using your iron
1. Insert the plug into a 230/240 volt power
outlet and turn the power on. The power
ON light (positioned on top of the handle)
will illuminate to indicate that the iron is
switched on and heating.
2. Turn the temperature dial to the desired
setting by aligning the setting on the
dial with the temperature indicator. The
thermostat light will illuminate to indicate
that the iron is heating to the selected
temperature. When the thermostat light
goes out the iron has reached the selected
temperature and is ready to use.
NOTE: When the temperature dial is changed
from a high setting to a lower temperature
setting during ironing, the thermostat light will
go out immediately. This indicates that the
iron is cooling to the selected temperature.
To ensure that the iron has reached the
selected temperature and is not too hot, wait
until the thermostat light comes on again an d
then goes out before ironing.
Steam ironing
Follow steps 1 and 2 above.
NOTE: When steam ironing, ensure that the
temperature dial is set to any temperature
within the steam band, and that the tank
is at least ΒΌ full of water.
3. Turn the steam dial to the desired
steam setting.
For best results, select the steam se tting
that corresponds to the selected temperature,
as indicated on the temperature dial.
6
Using your Sunbeam Verve Iron