24
Pigtail
Neutral Bus
Ground
TB2
TB1
Black (L)
White (N)
Green
Main
Service
Panel
with
GFCI
1-Pole
GFCI
Breaker
Ground/Bonding Lug**
1-Pole Circuit Breaker with 3-Wire Grounded Load Connection
(3 Wires to Hot Tub, 1-Hot (L), 1-Neutral (N), 1-Ground)
White (N)
Black (L)
120 VAC
Load Neutral Lug on Breaker
Note: service disconnect not
shown in this diagram.
The control box TB1 terminal
position varies between models.
BW
Hot Tub
Control Box
Connection Configuration #2
120 vAC Connections for denali, dover, Tacoma Models
(North America 60 Hz)
If the supplied
10 ft GFCI power cord
(US only) cannot reach a
dedicated, grounded wall
outlet, it is necessary to
install a 3-wire,
hard-wired connection.
These diagrams illustrate
that conguration.
For enhanced heater
performance the use of a
4-wire power connection is
necessary.
A pressure sensitive
terminal block (bonding
lug) is attached to the
outside surface of the
load box. This permits the
connection of a bonding
wire between this point
and any metal equipment
chassis, metal water
pipe, or metal conduit
within 5 ft (1.5m) of the
spa. The bonding wire
must be at least a #8
AWG (8.4 mm²) solid
copper wire.