SM-500 Bridge Mode Operation Diagram

13 • GUIDE USER 500-SM

Power Amp Assign Switch

set to “Bridge Mono” position.

12

AC FUSE

FUSE

LEFT SPEAKER

 

7 AMP

 

 

 

 

SLO BLO

 

 

L SPKR

 

 

 

FUSE

FUSE

 

 

 

 

 

 

8 AMP

 

120 VOLTS

 

 

 

 

 

50/60 HZ

 

 

 

 

 

 

 

840 WATTS

Center Bridge/Mono Speakon Output Jack must be used.

Speaker 1 = 8 Ohms

Speaker 2 = 8 Ohms

Note: When the power amp assign switch is set to the Bridge/Mono position, only the center Speakon output jack may be used. The SM-500 delivers a minimum of 500 Watts RMS into a 4 ohm load, and 400 Watts RMS into an 8 ohm load. Please make sure that your speaker system is capable of handling this amount of power.

SPEAKER OUTPUTS

 

EFFECTS

XLR PAD

PULL GND

 

LIFT

1

2

 

 

 

 

 

250W X2

 

EFFECTS RETURN

EFFECTS

 

STEREO

 

 

 

 

SEND

 

 

 

L STEREO R

 

 

 

TUNER OUT

 

 

 

 

MIN

MAX

RIGHT SPEAKER

 

 

 

 

R SPKR

 

 

 

BRIDGE

FUSE

FUSE

 

 

8 AMP

 

 

 

500W MONO

 

MONO

 

 

 

 

 

BALANCED OUT

 

 

 

LINE

DIRECT

This example shows two 8 ohm speaker enclosures connected in parallel for a total load of 4 ohms. This is the minimum impedance that the SM-500 is designed to drive safely in the Bridge Mode. Connecting multiple enclosures that have a combined total impedance of less than 4 ohms may result in damage to your amplifier.

The following cabinet configurations may be used:

one 4 ohm enclosure

one 8 ohm enclosure

two 8 ohm enclosures

four 16 ohm enclosures

SM-500 Power Output Ratings

Bridge/Mono Mode

500 Watts @ 4 Ohms

400 Watts @ 8 Ohms

250 Watts @ 16 Ohms (minimum load = 4 Ohms)