7EN
INTRODUCTION
(*) The unit can also be turned on by pressing these buttons.
1. Disc tray
• Place a disc when opening the disc tray.
2. OPEN/CLOSE A button*
• Press to open or close the disc tray.
3. Disc indicator
• This indicator lights up in blue when a disc is in this
unit.
4. Infrared sensor window
• Receive signals from your remote control so that you
can control the unit from a distance.
5. Display
• Refer to “Front Panel Display” on page 10.
6. STOP C button
• Press to stop playback.
7. PAUSE F button
• Press to pause playback.
8. PLAY B button*
• Press to start or resume playback.
9. POWER indicator
• This indicator lights up in red when the unit is active
and turns off when the unit is in standby mode.
10. POWERQ button
• Press to turn on the unit, or to turn the unit into the
standby mode. (To completely shut down the unit,
you must unplug the AC power cord)
11. SD card slot
• Insert an SD Memory Card and play back the
contents in it.
1. AC Power Cord
• Connect to a standard AC outlet to supply power to
this unit.
• Unplug this cord from the AC outlet to completely
shut down the unit.
2. DIGITAL OUT (OPTICAL / COAXIAL) jacks
• Use to connect an AV receiver / amplifier, Dolby
Digital / DTS decoder or other device with a digital
audio optical / coaxial input jack with a digital audio
optical or digital audio RCA cable.
3. COMPONENT VIDEO OUT jacks
• Use to connect a TV with component video inputs
with an RCA component video cable.
4. VIDEO OUT jack
• Use to connect a TV, an AV receiver or other device
with an RCA video cable.
5. AUDIO OUT jacks
• Use to connect a TV, an AV receiver / amplifier or
other device with an RCA audio cable.
6. HDMI OUT jack
• Use to connect a TV with an HDMI compatible port
with an HDMI cable.
Front Panel
PLAY POWER
PAUSE
STOP
DISC IN
SD card
OPEN/
CLOSE
8*76951 4
10
32*
11
Rear Panel
Y
VIDEO
OUT
PB/CB
PR/CR
OPTICAL
AUDIO OUT
COAXIAL
HDMI OUT
L
R
DIGITAL OUT
PCM/BITSTREAM
COMPONENT
VIDEO OUT
2435 61
Note
• Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
• This unit does not have the RF modulator.
INTRODUCTION C
ONNECTIONS
P
LAYBACK
F
UNCTION
S
ETUP
O
THERS
E5K41UD_EN.book Page 7 Wednesday, December 24, 2008 11:07 AM