Symmetricom 1100, 1000 manual Outstate, Rqlevel, SYS Events, Eqpt Disable Enable Disable

Chapter 6 Maintaining and Troubleshooting the TimeProvider

Troubleshooting the TimeProvider

Table 6-5. Event Codes (Continued)

Event ID	Keyword	AID	Default Value/	Description of Values
	Description	TYPE	Keyword
FRMTYPE	Indicates the type of	T1	Output = 2M	1.544M – 1.544 MHz
	input framing or the			2M – 2048 kHz
	input frequency. Sets			6.312M – 6.312 MHz
	the input framing type			CAS – CAS Input
				CCS – CCS Input
				ESF – Extended SuperFrame
				input
				CC – Composite Clock input
				ISOLATED_1 – Generates an
				isolated one test pattern for
				T1 outputs
				JCC – Japan Composite Clock
				JCC4 – Japan Composite
				Clock with 400 Hz
OUTSTATE	The specified output	T1	DISABLE	ENABLE – The output
	state has changed			generates the defined signal
				type
				DISABLE – Disables the
				output and clears all active
				alarms associated with the
				input
RQLEVEL	The received quality	T1	n/a	Displays the prior quality level
	level on the specified			followed by the new quality
	input has changed			level
		SYS Events
CLRDELAY	Time, in seconds,	EQPT	5 s	0 to 1000 s
	before a faulted signal
	indicates it is valid as a
	system reference
ELEVTIME	Indicates that Alarm	EQPT	DISABLE	ENABLE DISABLE
	elevation time (1440
	min.) is enabled or
	disabled
FACTORY	Indicates that the unit	EQPT	n/a	n/a
	has been reset to
	Factory default. All
	modules installed in
	the system are reset
FLTDELAY	Time, in seconds,	EQPT	10 s	1 to 15 s
	before faulted signal
	indicates it is not valid
	as a system reference

172 TimeProvider User’s Guide 097-58001-02 Revision G – April 2008