Tascam IF-CB DM-3200/4800settings, Setting the clock, Input settings (input routing), Output settings (output routing), ªªSYSTEM

DUAL LINK:

This shows the network connection method.

•• PreferPrimary(default setting):

The Primary network has priority. If the Primary network connection is lost, the mixer automatically switches to the Secondary network, and reconnects to the Primary network when it recovers.

•• AlwaysPrimary:

Only uses the Primary network.

•• AlwaysSecondary:

Only uses the Secondary network.

•• AutoSwitch:

Uses the Primary network at start-up. If the Primary network connection is lost, it switches to the Secondary network, and continues using the Secondary network even if the Primary network recovers. If the Secondary network connection is lost, it switches back to the Primary network.

NAME:

This shows the name of the installed IF-CB/DM card.

LATENCY:

This shows the current latency setting.

BITS:

This shows the current bit-rate setting.

ªªSYSTEM

This section shows information about the system.

F/W VER:

This shows the IF-CB/DM firmware version.

ERRORS:

This shows the number of errors that have occurred.

LOAD:

This shows the network load.

DM-3200/4800 settings

Setting the clock

1Press the PROJECT key to open the CLOCK screen where you can set the clock source. (See the “Clock setting” section of chapter 3 of the DM-3200/ DM-4800 User’s Manual.)

2Set the Fs MODE to 48k, and in the CLOCK SE- LECT area, select the SLOT where the IF-CB/DM card is installed. This enables stable operation even when switching between conductor and performer.

IF-CB/DM

CobraNet Interface Card

Input settings (input routing)

Make input settings on the INPUT page of the DM-3200/ DM-4800 ROUTING screen.

DM-3200 INPUT page

1Use the POD 4 knob to select the input source group. Input source groups are shown in the SOURCE SE- LECT list at the lower right of the screen.

2Use the POD 3 knob to select the input source rout- ing destination layer. Routing destination groups are shown in the LAYER SELECT list at the upper right of the screen.

3Use the cursor keys to select the source field, and use the JOG/DATA dial to select the input source.

4After making the selection, press the ENTER key to confirm it.

Output settings (output routing)

Make output settings using the OUTPUT SLOT page of the DM-3200/DM-4800 ROUTING screen.

DM-3200 OUTPUT SLOT page

TASCAM IF-CB/DM 3