Connections and installation |
|
Connecting to an Audio Mixer (not | Installation |
included) | •Install the unit on a horizontal surface protected from vibrations. |
| |
•Disconnect all units from the power source before making any con- | •Keep this unit as far as possible from speakers. |
nections. |
|
•Reconnect the AC power supply cord after all other connections | •Ensure the unit is not exposed to direct sunlight, dust, humidity, |
are complete. | |
| and heat from a heating appliance. |
| •This unit may pick up interference from a radio if there is one nearby. |
| Keep radios as far as possible from this unit. |
| Adjusting the height of the insulators |
| Place the unit where it is to be used and adjust the height of the legs |
| to make the unit horizontal. |
Preparatory adjustments |
|
| |
Horizontal balance and stylus pressure |
|
| |
1 Release the tone arm. | 3 Turn the stylus pressure control to “0” | ||
1. | Remove the stylus cover, taking care not to dam- | 1. | Return the tone arm to the arm rest and fix it |
| age the stylus, then release the arm clamp. |
| with the arm clamp. |
2. | Free the tone arm from the arm rest. | 2. | Turn the stylus pressure control to “0”. |
| Arm clamp | Hold the balance weight still while doing this. | |
|
|
| |
2 Adjust horizontal balance
1. Push the cue lever down.
2. Turn the
3. Turn the balance weight until the arm is approximately horizontal.
Take care at this time not to allow the stylus to touch the unit
Balanced
Too far forward
Too far back
Arm clamp
Arm rest
Cue lever
6
RQT7018