EDIT Menu

Figure 3 ￿69: Compare... Item Selected

10.Press the Set Result to button in the sub-menu to select MARKER1. This item is used to set where the results of comparison will be displayed.

11.If you would like to apply hysteresis to the reference waveform, select Hysteresis and enter a value. If hysteresis is not necessary, this item should be set to 0.

Hysteresis comparison uses a higher and lower signal level than the Source signal level; the degree is determined by the value set with the Hysteresis item.

12.Select Execute from the sub-menu.

Comparison Without Hysteresis Ð The left part of Figure 3 -70 shows a comparison of a triangular wave for Waveform2 and a square wave for Waveform1, with the results output to the Waveform2 MARKER display area. The figure on the right has been provided as an aid to understanding this process.

Comparison is only performed for the section of Waveform2 between the vertical bar cursors (in other words, from point 125 to point 875). Data outside this range is preserved as it was before comparison. The figure on the right shows the default marker set at point 0 remains ª1.º

3 ￿90

AWG2021 User Manual